Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: Oct 16, 2026
Knowledge is power! Please feel free to run your draft list of questions past the forum members. If you do decide to go ahead I recommend to get an...
If thats the case then I might be selective over what I have done, once I have the quotes, assuming you can cherry pick. Hopefully its a good one in ...
You are right. Thinking on this has evolved over the past 12 months following a lengthy discussion on this forum where we went through lots of differ...
I asked the buffer question also ("should I fit a buffer tank?"). It said (in summary) probably no and then went on to say: 'Instead, many expert...
Hi @notanexpert I think as others have said there are lots of good elements in ECO4 and it would be a pity to turn these down. The ASHP does depen...
Thats good news indeed, you are very likely almost there!
They need to be switched on/off together. The pump rates may differ however. There is a bit of an science to setting up PHEs which I haven't fully u...
@alfapat OK Im a bit stumped, but the good news is that someone in another thread has got it working (it may be a different generation but at least...
If it blows open a joint or a pipe you are correct of course. Perhaps more likely it will detect an existing slow leak due eg to a pinhole in a solde...
SPONSORS
Degrees of Separation
Latest Posts
-
RE: Do I add Air Con or MVHR to existing A2W ASHP?
We have ‘signed on the dotted line’ today for a Panason...
By Toodles , 2 minutes ago
-
RE: Heat pump branding. Clever, contemporary… or a bit too much?
...or it was there and was lost thanks to laziness and ...
By Majordennisbloodnok , 25 minutes ago
-
@bobflux Thank you for your response. I am trying to ...
By RonV. , 27 minutes ago
-
This post is about how I successfully configured a buff...
By Tony.Stolz , 4 hours ago
-
The installer visited yesterday and suggested the noise...
By JamesChatz , 5 hours ago
-
RE: Heat Geek installations: share your experiences
I struggled with this problem as well. An independent t...
By L8Again , 6 hours ago
-
RE: HeatGeek vs Octopus surveys: puzzling disparity - any ideas why?
Your house sounds a lot like mine. 2 surveyors each sp...
By JamesPa , 8 hours ago
-
RE: Heat Geek Zero Disrupt: Are We Sleepwalking Into Another Race to the Bottom?
Thats true only if you do the wrong experiment. Done c...
By JamesPa , 9 hours ago
-
RE: How should the Boiler Upgrade Scheme be reformed?
@temperature_gradient Isn't that just describing a regu...
By Prunus , 9 hours ago
-
RE: battery storage without solar
As of October 1st they need specific qualifications to ...
By EtchedPixels , 22 hours ago
-
RE: Renewables & Heat Pumps in the News
With regards to the BUS grant raid, I gave it more thou...
By ASHP-BOBBA , 22 hours ago
-
RE: Why are ASHP installs so expensive?
The whole system seems to work on the basis of...
By ian33a , 23 hours ago
-
RE: Missing flow temperature in Heat Geek proposal
Good plan. If you can get half hourly meter readings a...
By JamesPa , 1 day ago
-
RE: Heat Pumps Without Grants: Would You Have Installed One & Will You Now?
@editor Most certainly. The heat pump was an ideal s...
By Abernyte , 1 day ago
SPONSORS
