Forums

Forums
Members
Richard24738
Activity
 
Notifications
Clear all
Richard24738
@richard24738
Member
Estimable Member
1029 kWhs
Joined: Mar 14, 2024
Last seen: Mar 9, 2025
Profile Activity
Topics: 5 / Replies: 64
AllTopicsReplies
Topic
Insulating brass fittings in Loft
2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Replies: 10
Views: 272
Reply
RE: hum/whine from Wilo circulation pump

@johnr I think I may have missread something somewhere as I now understand that the secondary pump flow rate should be equal to or greater than the pr...

2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: hum/whine from Wilo circulation pump

@johnr Hi. I think I may have missled you in that my buffer is configured in exactly the same way as you describe. Whats a little bit concerning for...

2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: hum/whine from Wilo circulation pump

@toodles Thanks. I haven't forgotten you. Due to the low outside temperatures, my ecodan is going into anti-freeze at night when the set back means ...

2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: hum/whine from Wilo circulation pump

@johnr Thank you for explaining how your buffer is connected and the details of the temperature at each of the four ports. Both &toodles and I h...

2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: hum/whine from Wilo circulation pump

@toodles Of course the difference between the Daikin and Mitsubishi is that the Daikin has a built in primary circulating pump, controlled by the Daik...

2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: hum/whine from Wilo circulation pump

@grumpidoc Please remember I am just a new heat pump user and not a heating engineer but I have picked up a few things on my journey! None of the belo...

2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: hum/whine from Wilo circulation pump

@grumpidoc You may be interested in what I have done to reduce my system noise. My system is Ecodan 11.2kw > Primary Pump (Grundfos UPS2 25-80) &...

2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - Auto Adapt

@boycey Yes, the thermostat on my Ecodan is on the back in the top corner. When the engineer replaced the thermostat, I suggested that it could perh...

2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - Auto Adapt

@boycey Legionairres taking too long: Mitsubishi diagnosed a defective immersion heater. Installer is coming next week to replace it. Outside temp...

2 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Is my Ecodan well installed and setup?

@trbob I went down the Mitsi Engineer route unfortunately with the fee. Report has just come in to say that the immersion had "irregular figures whe...

4 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - Legionella Operation Time and Target Temperature

@trbob Very interesting. It took round about an hour for your immersion to get from 49.5 to 59.5. Probably acceptable It looks like the Mitsi soft...

4 months ago
Forum
Air Source Heat Pumps (ASHPs)
Page 2 / 6
Share:

Join Us!

Heat Pump Dramas?

Thinking about installing a heat pump but unsure where to start? Already have one but it’s not performing as expected? Or are you locked in a frustrating dispute with an installer or manufacturer? We’re here to help.

✅ Pre-Installation Planning
✅ Post-Installation Troubleshooting
✅ Performance Optimisation
✅ Complaint Support (Manufacturer & Installer)

👉 Book a one-to-one consultation now.

Latest Posts

x Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
Shield Security →