Activity
 
Notifications
Clear all
Gfletcher
@gfletcher
Member
Trusted Member
243 kWhs
Joined: Oct 8, 2022
Last seen: Aug 17, 2023
Topics: 4 / Replies: 20
Reply
RE: Mitsubishi ASHP - Circulating pump noise?

Hi @Snuffy, we had the same with our Mitsubishi system, it did calm down after a while (a good few weeks). I found that there was air in the system se...

1 year ago
Reply
RE: Mitsubishi 8kW - strange energy use readings

It's good that this thread is still going and from a selfish perspective I'm glad that it's not just me! Also, thanks @steevjo for posting the respons...

1 year ago
Reply
RE: Octopus Energy Heat Pump Quote

@squeakysim - that seems like a good quote. We installed an 8.5kw Ecodan and a Mixergy tank (more expensive than the normal system tank) at a cost of ...

1 year ago
Reply
RE: Ecodan - rubbish data

Thanks @HarriUp. I'll look into those, I have also been looking at the Open Energy Monitor. Cheers Gavin

1 year ago
Reply
RE: A Beginner's Guide to ASHP Monitoring

@Derek-M - good point, but I get COP envy.... More seriously though, I suppose, having a forum like this and enabling 'peer to peer' learning with t...

2 years ago
Reply
RE: A Beginner's Guide to ASHP Monitoring

Hi @Cathoderay, thanks for starting this. I have almost exactly the same experience as you with multiple tabs open and nowhere to go! I am currently u...

2 years ago
Reply
RE: Air in my radiators

Thanks for the additional info - yes, some small tinkling noises, and yes, only started using properly at the start of Nov. We do have air release val...

2 years ago
Reply
RE: Air source heat pump roll call

Hi, Here's my info Forum Handle: gfletcher Manufacturer: Mitsubishi Model: Ecodan 8.5kW with mixergy cylinder Type: ASHP Arrangement: Monobl...

2 years ago
Reply
RE: Air in my radiators

Hi Derek, Thanks for the reply. Yes, I am topping up after bleeding. The pressure doesn't drop until I bleed the rads - but since installation I hav...

2 years ago
Reply
RE: ASHP and Tado

@morgan Brilliant - thanks, I'll look at the curve settings.

2 years ago
Reply
RE: ASHP and Tado

@mjr Thanks for that - I have now switched it over and the screen looks like this - Do I need to do anything else e.g. with the +0degrees bit? ...

2 years ago
Reply
RE: ASHP and Tado

@benseb Thanks - I'll take a look. I was keen on the Tado system so I could change the temp of individual rooms. Even when I put the Tado onto 'boost ...

2 years ago
Page 1 / 2
Share:

Join Us!

Latest Posts

Heat Pump T-Shirts

Delta T Sounds Greek to Me
x  Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
Shield Security