Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: Oct 26, 2026
Can I refer back to your first post in this topic? You stated your strategy was to use three battery packs.The only cables which have to carry a pos...
That will probably work fine, but is noisy and doesn't offer the optimal strategy. The output side of a fan has turbulent air.It's 'out of control' ...
I'm unsure of the sources from which you derived your initial list, but I'm pleased to see it being altered as others contribute to this topic. Low-...
I'll have to think a bit about the balancing method. I'm not familiar with the Active-Balancer you're using.The ones I have here are the larger/newe...
No, it's the existing Seplos BMS which will be getting warm.It should be burning off the extra voltage through its resistors.The whole point of a pass...
The active balancer is only measuring differential voltage. Since each wire has approximately the same resistance added to it by the fuseholder, the v...
Interesting points you're making @robl There is probably little harm in doing things unconventionally... especially when in discussion with others o...
That was also my interpretation.But it doesn't seem to me a feature likely to be used by those reading this Forum. Keeping a battery topped-up is us...
Welcome @jeepster So you seem to have started out at the Rolls Royce end of the market with Victron kit,to which you then add the tried & truste...
If you need more help @majordennisbloodnok then please ask. You can post a photo of wires leading from your Growatt connection ports if you'd like c...
To save you flitting all over the place, let me re-post here a basic introduction to Modbus over RS485 RS485 is a serial protocol which runs ove...
So let me clarify... The simplest strategy is to use Modbus commands over RS485.The manual indicates at least two such ports are available for you t...
SPONSORS
Degrees of Separation
Latest Posts
-
RE: Tradespeople on Their Phones: What’s Acceptable When They’re Working in Your Home?
I know most of the folks I use pretty well so I'm fairl...
By EtchedPixels , 5 hours ago
-
RE: The Changing Jet Stream Could Challenge UK Air Source Heat Pumps
@susannasaunders I'll set this up and start monito...
By Rob of York , 6 hours ago
-
RE: Electrical works for air to air heat pump
An electrician who signs off work is responsible for it...
By EtchedPixels , 11 hours ago
-
RE: Are there any comparisons of DHW heat stores around?
@sarahemmm I have done things the opposite way round I ...
By Toodles , 11 hours ago
-
RE: 15kw pump for 225m2 1990's house - over kill?
@seaviews I have read you latest response re buffer ...
By JamesPa , 1 day ago
-
RE: How will removing the standing charge on gas bills benefit heat pumps?
The BUS grant funding for 2026/27 will run out at the c...
By Rob of York , 2 days ago
-
-
@editor Ouch, sorry to re start the tick. I had assume...
By DavidB , 3 days ago
-
RE: Say hello and introduce yourself
@e-a-west as the good Major said, welcome to the forums...
By Mars , 3 days ago
-
RE: How much of your renewable and home setup would still work if the internet went down?
Yes I actually have a copy of a tool that whenever a ce...
By EtchedPixels , 4 days ago
-
RE: Indevolt Batteries UK Support & Info Thread
@editor Hi, To resolve this, please tap on the A...
By Indevolt Tech , 4 days ago
-
RE: Double or Triple Glazed Windows?
Posted by: @singlespeed With 9 years repairing windo...
By Rob of York , 5 days ago
-
@transparent we’re still running a secure version of PH...
By Mars , 5 days ago
-
RE: How quickly would you want/expect heat recovery to take from setback?
Much longer than that here. The heating isn't even on. ...
By bobflux , 5 days ago
SPONSORS
