Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: Aug 20, 2026
Can you please clarify what this graph is, it appears to have both setback and no setback on the same days? Also when you did the AUC calculation re...
Yes and Yes. Conservation of energy must eventually apply, but may take a long while for equilibrium to be re-attained, and my suspiscion is that in ...
The '10%' refers to the change in deltaT between IAT (20C->19C) and OAT (10C). House loss (which is how the '10%' is being used) is proportional ...
Provided the 'control' period from which these were derived is representative of the test period I would agree. If any changes have been made to the ...
Dare I say 'builders innit' (i think that's the appropriate slang - but its not my specialist subject!). The electrical institutions, in fairness, h...
True (which is one reason I advocate it for pump sizing), but it doesn't support extrapolation to other scenarios (ie houses) unless you have enough e...
The conclusion is right but just to correct the units - you have a 10kWh battery and it charges at about 2.1kW. Think of kW like speed and kWh like ...
You could well be right. I didn't look into it that far because I fail Octopus Intelligent Go at the first hurdle. Although I have an EV its only co...
I don't think so and hope not. I grant that heating, while fundamentally simple, is actually rather complex. However there is, in principle, a vast ...
All agreed, with the possible comment that theoretical models are (currently) invariably based on well adjusted/designed heat pump systems, and we kno...
- 27 Forums
- 2,746 Topics
- 64.6 K Posts
- 1,210 Online
- 7,153 Members
Join Us!
Installer Finder
Degrees of Separation
Latest Posts
-
RE: Do I add Air Con or MVHR to existing A2W ASHP?
Cloudy one done, might get the sunny one tomorrow or de...
By Watcher , 8 hours ago
-
RE: The good, the bad and the not that great – my heat pump installation
@burtis, I’ve followed this thread pretty much from the...
By Mars , 1 day ago
-
RE: Starting Our Heat Pump Journey: 1962 build 3 bed detached house
First time poster here but I can share my experience as...
By SCH , 1 day ago
-
At the risk of going on: A slight side issue for a foru...
By Bart , 2 days ago
-
RE: Is it the house or the equipment?
...which, I've found out, is pretty much impossible to ...
By Majordennisbloodnok , 2 days ago
-
RE: Mitsubishi Ecodan FTC6 settings
The Mitsi remote thermostat should not be plugged into ...
By F1p , 2 days ago
-
RE: PV and battery long payback - sense check query
@jamespa I was just commenting on the speed, not sug...
By Batpred , 2 days ago
-
Readers here please note that Derril Water and many oth...
By Transparent , 3 days ago
-
RE: Advice on Vaillant Sensocomfort
Oops, I meant Sensocomfort (the UI to the controls)
By Batpred , 3 days ago
-
RE: Heat Pump Training vs. Real-World Installation
Our instal was very much the opposite. White haired blo...
By Batpred , 3 days ago
-
RE: Flushing system, cleaning and inhibitor
While skim reading a manual for our Vaillant HW tank, I...
By Batpred , 3 days ago
-
RE: 'Chinese Diesel Heater' to heat the home .....
Old thread but I'm new to the forum so new to me. How...
By BlizzardGreen , 3 days ago
Members Online
No online members at the moment



