Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: Sep 6, 2026
This just posted by Byline Times:
I used to (and still do to some extent) have "water flow" noise in my pipes which made me turn down the circulating pump at times, and I guess this i...
@editor The trick to an inside unit installation is to put it in someone else's house 😉
My parameters are: 42 00 = 0 (so the next three values don't matter, and they are the default values...) 42 01 = 3 42 02 = 5 42 03 = 3 51 11...
@damonc The only time the circulation pump on my HP runs 24x7 is when it's in "frost protection" mode i.e. OAT goes below 3C, when it stays running un...
@damonc I was refering to the 'standard' energy sticker that comes with the HP which I think indicates (for my 10kW Grant) that output rating varies b...
@steam-powered Hi - for 'power consumption' I use the '01 06' value (from the controller), which is in units of 100W, but most of the figures presente...
Hi, I have a Grant 10kW (nominal 9kW for the UK), which is, I believe correctly sized, but this is a retrofit on a 70s converted bungalow, with radi...
I've been following this thread since it began, and it's very disappointing that the installers, and follow-up trade still haven't sorted your issues ...
@grantmethestrength With respect to weather forecasts, I used to have my "DHW hour" fixed at 3-4pm, for obvious reasons, but have changed it to look a...
If it was working okay last winter, and not this, then implies something in the set-up has changed, or something is broken (but if that was the case I...
Sorry, no. My Grant has only died once and that was me causing the RCBO to trip. If the fault reset didn't work (and assume you also tried the all-pow...
SPONSORS
Degrees of Separation
Latest Posts
-
RE: Siting of the external sensor on a heatpump
Of course had the heat source been a heat pump it would...
By JamesPa , 56 minutes ago
-
-
RE: Recommendations in Ely (Cambs) area for Full setup checks on Nibe HP setup for House.
In fairness all heating has cost a lot to run in recent...
By JamesPa , 3 hours ago
-
RE: Is it the house or the equipment?
@springswood We have two Daikin single split A2A syst...
By Rob of York , 4 hours ago
-
RE: Next steps on my ASHP journey: Radiators and Pipework
You should (almost) always reject having a buffer, by w...
By JamesPa , 1 day ago
-
RE: Navigating the World of Refrigerants In Heat Pumps: A Guide for Homeowners
Indeed we are invvestigating AC at present and are havi...
By Toodles , 1 day ago
-
No, but the heat pump must be capable of delivering a S...
By JamesPa , 2 days ago
-
RE: Daikin ESPAltherma and Home Assistant installation
It's laziness lol The PV system is very chatty, meter...
By bobflux , 2 days ago
-
RE: Problems with sizing a replacement for a Viessmann Vitocal 200-S
R (The R Project for Statistical Computing, I use it wi...
By cathodeRay , 2 days ago
-
RE: Vaillant Arotherm Plus 7KW need a service on it
booked it with Vaillant. will use them until i can find...
By AdamK , 2 days ago
-
RE: Adventures in heat loss calculations
I have seen it stated that the declared calorific value...
By JamesPa , 2 days ago
-
RE: Two heating zones to one zone
@transparent Many thanks. The garage is fairly well ...
By Profzarkov , 3 days ago
-
RE: Vaillant Aurotherm - Heater Wire Position
Ah, good point. I need to check if this was installed i...
By Batpred , 4 days ago
-
@batpred thanks for getting a copy. Appreciate the supp...
By Mars , 4 days ago
SPONSORS
