Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: Sep 1, 2026
@benson No idea why mine doesn’t work, all I see on homely connect is a map of the world and some search terms, none of which comes up with any hea...
@agentgeorge isn’t the idea that about 70% of the heat for the upper floors comes from the lower floor. We did the opposite, changed 3 zone GCH back i...
@agentgeorge it might be of interest I did our vaulted ceiling with 135mm PIR board and a skim and it changed an almost unbeatable room into a saun...
@jamespa Although sharing many of the same philosophical sentiments about the impact of technology on the human condition with Ted Kaczynski or Heideg...
@batpred thanks yes, we used an analogue phone with an older version of the hub too, it used to plug into a specific phone port. But that was when w...
@jamespa Ta, will do. worst case I will be on a 30 day contract, so can exit without too much pain and already have telephony via mobile. I was wi...
@majordennisbloodnok Thanks. I only ordered the hub yesterday, it’s not here yet. Because of the complicated arrangement I have with the VM rep ( h...
@majordennisbloodnok VM hub 5. I read that I needed to switch it to run on modem mode on the VM tech pages in order to facilitate non VM VOIP provisio...
@jamespa Thanks. Yes I get a DECT station with the yealink handsets. It’s a bit of a pain I have to “waste” one of the mesh stations to act as a route...
@majordennisbloodnok Thanks, so in summary. 1. Switch the VM hub to be in modem mode. 2. Connect the Ethernet cable from the IP phone into the ...
@jamespa I can’t remember complaining, my dad had to execute the wire taps which were in a restricted area of the exchange so he’d leave me with the l...
- 27 Forums
- 2,767 Topics
- 65.1 K Posts
- 2,567 Online
- 7,169 Members
Join Us!
Installer Finder
Degrees of Separation
Latest Posts
-
RE: Next steps on my ASHP journey: Radiators and Pipework
If you are considering phasing the project, then I woul...
By GrahamF , 8 hours ago
-
RE: Siting of the external sensor on a heatpump
Of course had the heat source been a heat pump it would...
By JamesPa , 10 hours ago
-
Never assume, it makes an ass of u and me! OK, tha...
By JamesPa , 11 hours ago
-
RE: Recommendations in Ely (Cambs) area for Full setup checks on Nibe HP setup for House.
In fairness all heating has cost a lot to run in recent...
By JamesPa , 13 hours ago
-
RE: Is it the house or the equipment?
@springswood We have two Daikin single split A2A syst...
By Rob of York , 14 hours ago
-
RE: Navigating the World of Refrigerants In Heat Pumps: A Guide for Homeowners
Indeed we are invvestigating AC at present and are havi...
By Toodles , 2 days ago
-
No, but the heat pump must be capable of delivering a S...
By JamesPa , 2 days ago
-
RE: Daikin ESPAltherma and Home Assistant installation
It's laziness lol The PV system is very chatty, meter...
By bobflux , 2 days ago
-
RE: Problems with sizing a replacement for a Viessmann Vitocal 200-S
R (The R Project for Statistical Computing, I use it wi...
By cathodeRay , 3 days ago
-
RE: Vaillant Arotherm Plus 7KW need a service on it
booked it with Vaillant. will use them until i can find...
By AdamK , 3 days ago
-
RE: Adventures in heat loss calculations
I have seen it stated that the declared calorific value...
By JamesPa , 3 days ago
-
RE: Two heating zones to one zone
@transparent Many thanks. The garage is fairly well ...
By Profzarkov , 4 days ago
-
RE: Vaillant Aurotherm - Heater Wire Position
Ah, good point. I need to check if this was installed i...
By Batpred , 4 days ago
-
@batpred thanks for getting a copy. Appreciate the supp...
By Mars , 4 days ago



