Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: Aug 22, 2026
My neighbour had a similar install through the Local Authority - he qualified on health grounds (definitely not on low income or means tested benefits...
I signed up initially and got confirmation for the first session on 15 Aug. I didn't receive any notification of the session on 18th Aug, but did rece...
The Ripple calculator says annual savings of £385 for 2,892 Watts, 7,000 kWh of electricity per year (at a cost of £4961), which works out at 5.5p per...
Where did you get this? I do not believe this is correct, or at least it wasn't last time I looked into Ripple. The amount you receive is based on y...
I would guestimate it would be quite low. Most solar generation will occur in summer when heat pump usage will be minimal. Our own small 3.6kW solar a...
I should add, being an investment, the value of your investment may rise or fall in value and that dividends are not guaranteed. Do your own research ...
Ripple is best viewed (because that's how it acts) as a hedge against higher electricity prices - if prices go up, Ripple does very well and helps off...
@mellow Thanks. Given there is a scheme requirement to improve the rating from one band to another, one wonders how they demonstrate compliance if the...
The COP may actually be better at that higher flow temp due to the reduced (or elimination of) cycling? All else being equal, a lower flow temp will g...
This is essentially how I have been running my Samsung - FSV #2091/2092 set to option 1 so the compressor can only be turned off by the 3rd party room...
SPONSORS
Degrees of Separation
Latest Posts
-
RE: Do I add Air Con or MVHR to existing A2W ASHP?
About the original question: Flow rate for MVHR is ad...
By bobflux , 25 minutes ago
-
Britain’s Heat Pump Shitshow is now available to pre-or...
By Mars , 23 hours ago
-
RE: The good, the bad and the not that great – my heat pump installation
@burtis, I’ve followed this thread pretty much from the...
By Mars , 3 days ago
-
RE: Starting Our Heat Pump Journey: 1962 build 3 bed detached house
First time poster here but I can share my experience as...
By SCH , 3 days ago
-
RE: Is it the house or the equipment?
...which, I've found out, is pretty much impossible to ...
By Majordennisbloodnok , 3 days ago
-
RE: Mitsubishi Ecodan FTC6 settings
The Mitsi remote thermostat should not be plugged into ...
By F1p , 4 days ago
-
RE: PV and battery long payback - sense check query
@jamespa I was just commenting on the speed, not sug...
By Batpred , 4 days ago
-
Readers here please note that Derril Water and many oth...
By Transparent , 4 days ago
-
RE: Advice on Vaillant Sensocomfort
Oops, I meant Sensocomfort (the UI to the controls)
By Batpred , 4 days ago
-
RE: Heat Pump Training vs. Real-World Installation
Our instal was very much the opposite. White haired blo...
By Batpred , 4 days ago
-
RE: Flushing system, cleaning and inhibitor
While skim reading a manual for our Vaillant HW tank, I...
By Batpred , 4 days ago
-
RE: 'Chinese Diesel Heater' to heat the home .....
Old thread but I'm new to the forum so new to me. How...
By BlizzardGreen , 5 days ago
SPONSORS
