Last seen: Mar 20, 2024
Where is your water tank? I'm wondering how it gets so cold, way below room temp. Does it ever actually get to 50 deg at the taps?
14kW Ecodan, rural East Midlands, largish 1990 bungalow 21.5 throughout mostly 24/7. Heating and HW combined- December 699kWh COP 2.95 January 947kWh...
done from me too
Looks good so far. The cycling may be the low flow temps rather than the energy (although they are of course related). Ecodans seem to struggle to m...
@gshpwoes scalding hot DHW suggests it's using an immersion heater. This would use a lot of energy. Does your GSHP also have a backup heater, i.e...
@davidalgarve The figures from the control panel and those from Melcloud should be the same, as yours are. I was talking about using external heat ...
I have used both on the same system and the previous internal measurements of COP were very similar to the current externally metered ones.
The high delta T (difference between THW1 and THW2) also supports a too low flow rate. Are all the ufh/radiators all getting warm? Even at an average...
@bontwoody I agree with most of your comments and I especially agree the installer is either making things up or is really incompetent. On the sizi...
I'm not sure about the relevant consumer law. It might be hard to prove it's not fit for purpose if it's able to heat the property and especially if ...
@bontwoody, it does seem excessive for a 100m2 house that has a heat loss in the normal range.
- 24 Forums
- 1,427 Topics
- 30 K Posts
- 32 Online
- 1,212 Members
Join Us!
Latest Posts
-
@editor Perhaps if we could run the windmills in revers...
By Toodles , 6 mins ago
-
RE: Noise problems with newly installed Samsung 8kW ASHP
Thanks @lokisam We've been lucky over the last week ...
By sjn , 57 mins ago
-
@bontwoody I used the website link to contact them for ...
By Toodles , 2 hours ago
-
RE: Samsung ASHP power cycling
I have considered that and I would have expected to see...
By Blaine_t , 3 hours ago
-
RE: Is this a bad installation and is there something wrong with my Samsung heat pump?
@transparent that controller was moved from the loft an...
By David999 , 4 hours ago
-
RE: 14kW Midea ASHP in an old leaky building
Hi @batalto. I see you have a Midea ASHP and I am sched...
By Kbedders , 5 hours ago
-
RE: Observations on my Ecodan's estimates of energy consumed and delivered
yes ours is set exactly as you stated. 72W for pump4. Z...
By SUNandAIR , 5 hours ago
-
RE: Additional ASHP kW for DHW cylinder?
We're in a similar boat to you with a hodgepodge of dif...
By Mars , 6 hours ago
-
Insulation of flow and return Heat Pump piping
I know mention has been made of ties on insulation runs...
By Toodles , 6 hours ago
-
RE: Heat Pump Truth or Myth#2 - Cycling uses a lot of power and ruins your COP
@jamespa Possibly a load of hot air then?😉 (Sor...
By Toodles , 7 hours ago
-
RE: No-code, plug-and-play monitoring for your heat pump
Anyway, so far we have all missed the main protagonist ...
By Toodles , 7 hours ago
-
Rising Damp – Production Recommendation
We've noticed some rising damp around a window after th...
By Mars , 7 hours ago
-
RE: Bivalent (or even trivalent!) system design options for a new GSHP installation
Right, back to the topic at hand. To answer some of you...
By Algienon , 20 hours ago
-
RE: Are Octopuses Slowing Consumer Adoption of Heat Pumps?
@ivanopinion Im in the same team as Ivan. I think for a...
By bontwoody , 1 day ago
-
RE: ASHP Cut-off Temperatures: What's Your Setting and is a Your Heating Still On?
@technogeek Our Homely controller turns the heating on ...
By Toodles , 1 day ago
-
RE: Issues with Vaillant connectivity via the MyCONNECT gateway
@drew-pa I don't know about hard work! It is pretty cl...
By dr_dongle , 2 days ago
-
RE: Are Solar Diverters Necessary for Homes with ASHPs and Solar PV?
@editor No, I made one 😀 Loft insulation all...
By Andris , 3 days ago
-
@hughf Thanks for that. Ah so they are talking about ...
By IRMartini , 3 days ago
-
RE: Ecodan software update. Real or scam?
@abernyte, hmm, must have been a major disruption if 40...
By Mars , 3 days ago
-
RE: Installing your own ASHP - DIY
I’m in the DIY camp, completed the install last Septemb...
By HughF , 3 days ago
Latest Topics
-
By Toodles 23 mins ago
-
By Blaine_t 5 hours ago
-
Insulation of flow and return Heat Pump piping
By Toodles 6 hours ago
-
Rising Damp – Production Recommendation
By Mars 7 hours ago
-
Additional ASHP kW for DHW cylinder?
By Project_Electrify 22 hours ago
-
By IRMartini 3 days ago
-
Riello / Midea - modbus set flow temp
By stuartornum 4 days ago
-
Ecodan software update. Real or scam?
By Morgan 4 days ago
-
Noise problems with newly installed Samsung 8kW ASHP
By Lokisam 6 days ago