Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: Nov 22, 2024
Thanks James The truth is that I am probably being a bit premature in my thinking as we still have a couple of small but critical areas of the house...
Hello. Update and questions... So we have been running as previously described ie manually turning on the ashp and the UFH pump. The Ecodan is runni...
@gary If you are able to run continuously at 32 C (or whatever) how do you control the overall house temperature? Presumably at 32 the floor even...
@hcas Thanks.So if I can increase the flow rate by the correct proportion across all the circuits that should help the transfer and therefore reduce c...
So I increased the flow temperature to 32 and it ran for over 90 minutes before going off. It then cycled but I'll have to watch it to see how freque...
@hcas thank you very much for replying. I guessed it was essentially that the Ecodan was thinking that the flow and return temperatures were too clo...
SPONSORS
Degrees of Separation
Latest Posts
-
RE: Why are ASHP installs so expensive?
While heat loss is a very important (and fascinating) s...
By springswood , 1 hour ago
-
RE: Heat Pump deployment statistics: June 2026
To my eyes, sat behind all of this is a basic policy ma...
By Temperature_Gradient , 13 hours ago
-
Thank you @majordennisbloodnok – that means a lot, part...
By Mars , 17 hours ago
-
We’ve just passed 20 million forum views! 🎉
It's official. The Renewable Heating Hub forums have of...
By Mars , 18 hours ago
-
RE: Missing flow temperature in Heat Geek proposal
That calculation is reasonable, output is proportional ...
By JamesPa , 20 hours ago
-
RE: Recommendations in Ely (Cambs) area for Full setup checks on Nibe HP setup for House.
Have you looked at the Nibe website? They list their ap...
By Lizzie , 21 hours ago
-
RE: Who's your electricity provider and what's your tariff?
@batpred When the raw material input has increased in c...
By Papahuhu , 2 days ago
-
We kept ours and Heat Geek would have been in touch if ...
By Batpred , 3 days ago
-
RE: Starting Our Heat Pump Journey: 1962 build 3 bed detached house
@ian-s I would encourage you to have a conversation ...
By Rob of York , 3 days ago
-
RE: Is it the house or the equipment?
Thanks @jamespa The last hard to fix draughts in the...
By springswood , 3 days ago
-
RE: Vaillant Arotherm – Using Heating
@l8again Mine is typically using 11w including the i...
By Batpred , 3 days ago
-
RE: Next steps on my ASHP journey: Radiators and Pipework
If you have a flowmeter and two temperature probes, the...
By bobflux , 3 days ago
-
RE: Siting of the external sensor on a heatpump
@jamespa Absolutely. Even if the same mistake was mad...
By Batpred , 4 days ago
-
SPONSORS
