Activity
 
Notifications
Clear all

Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!

ASHP-BOBBA
@ashp-bobba
Member Professional Installer
Honorable Member
Joined: Dec 6, 2024
Last seen: Mar 12, 2026
Topics: 2 / Replies: 408
Reply
RE: Daikin Altherma 3 LT compressor longevity question

  With regards to line 2, could it be that the (demand) was not met and although the external temp was 21.2c (some solar gain no doubt) the act...

6 hours ago
Reply
RE: Ecodan Cylinder Possible Weeping Around Thermostat Port

This is likely thread sealant for the pocket plug, very easy fix if it starts oozing out, unless you get an actual leak it is probably fine, what you ...

2 weeks ago
Reply
RE: Struggling to get CoP above 3 with 6 kw Ecodan ASHP

Your DT is to low, you do not have enough heat exchange would be my 1st thought, it might explain the short cycling. How old is your home as the app...

3 weeks ago
Reply
RE: Call for heat on open loop weather comp system

I don't know Grant system but most ASHP are very similar. The grant controller should act as the only stat on an open loop for best performance and yo...

3 weeks ago
Reply
RE: ASHP fault for DHW only with high set point – P1 error on 6kW Grant Aerona 3

Yes, I have seen "many times" where the indirect coil connections raise up but no air bleed, it only takes a small amount of air in the line to effect...

3 weeks ago
Reply
Reply
RE: Underfloor Heating Installation Issues with Heat Pump

Just one more thing to add, the best UFH is thick screed, next is overlay and next is deflector plates, my advice is if they are looking to give you 5...

3 weeks ago
Reply
RE: Underfloor Heating Installation Issues with Heat Pump

These deflector plates are very soft, you can cut them with sharp taylor scissors, sheers or cheep drill nibler. I even found that for you 🙂 as y...

3 weeks ago
Reply
RE: Underfloor Heating Installation Issues with Heat Pump

@maximumdo this one has 200mm centres so you could trim the plate to 70mm each side (70+200+70= 340mm) of the pipe so they overlap by 20mm to...

3 weeks ago
Reply
RE: ASHP fault for DHW only with high set point – P1 error on 6kW Grant Aerona 3

I don't know the Grant system but this is common when there is air trapped in the tank circuit which causes the water to have reduced flow and reduced...

3 weeks ago
Reply
RE: Underfloor Heating Installation Issues with Heat Pump

To add, you will probably find the UFH brand they used sells a spreader plate application to suit the pipe, if not I think as standard they take a 16m...

3 weeks ago
Page 1 / 35
Share:

Join Us!

Latest Posts

Members Online

Click to access the login or register cheese
x  Powerful Protection for WordPress, from Shield Security PRO
This Site Is Protected By
Shield Security PRO