Last seen: Jul 21, 2024
SITREP 1. Evening charging seems fixed. Adjusting the shutdown, low battery and restart fixed that. Apparentl y the inverter wil...
Grid Charge in battery setting is the 1 I suspect. Note - tried many setting to get it to stop charging this evening. I don't think I'd bu...
Ok, I can handle that - will set for voltage mode and try. Regarding the evening charging - how do I combat that? Under battery settings, Grid...
@robl So... The Sunsynk is not a intuitive firmware. That's is putting it mildly. The exchange between it and the battery, appears to be gettin...
@robl Cheers for the screens dump - really useful. Battery charged fine overnight. Raises some questions, Your shutdown, low and restart are 0%, 1% ...
Seems the timer was the issue, I had time 1 set wrong. Worked @08:00 and all day so far.
The manual says 80%DOD - for 3500 cycles My interpretation of that is 10%~90%. On other forums, the common consensus is 20%~100% = 80%DOD This i...
So close..... @robl My battery discharged all day lovely got to 20:30 before it ran out - 20%SOC once it hit 20% - the Sunsynk immediat...
@adrianmc Ive it setup 90% ~ 10% - to match the 80% DOD rate that is listed in the Fogstar manual.
@robl And as everyone said and expected, the CT cabling was the wrong way round. The manual is awful in that section, basically guess the colou...
So life got in the way, as it normally does - I have eventually got onto it and installed it - following regs as best i can. MCB Surge protect...
@misterb @editor So it has actually arrived. Will post a decent update after I attempt an install this weekend.
- 21 Forums
- 1,814 Topics
- 39.1 K Posts
- 15 Online
- 2,130 Members
Join Us!
Latest Posts
-
RE: Can you work an ASHP too hard?
As someone with an over-sized HP and the lower level of...
By HarriUp , 2 hours ago
-
RE: Best temperature wave form for best economy and efficiency .
I find the graphs somewhat hard to reconcile against th...
By HarriUp , 3 hours ago
-
RE: ASHP and how it should run and potential kw consumption?
You can help things by putting the DHW on to a timed op...
By Judith , 4 hours ago
-
RE: Vaillant Arotherm ASHP gets noisier when it gets colder outside
Quite possibly. As I mentioned above the 'ideal' produ...
By JamesPa , 4 hours ago
-
RE: Is it crucial to get flow temperatures with heat pumps right?
The bodies of TRVs usually have an arrow on them. If i...
By JamesPa , 5 hours ago
-
RE: Say hello and introduce yourself
Thank you Transparent ...much appreciated 😊 ...
By ivanhoew , 6 hours ago
-
RE: ASHP for small garage and workshop
@transparent Hello. This will not be covered on any gra...
By BobTSkutter , 7 hours ago
-
RE: Adding data centre electricity costs to domestic energy bills?
Greg Jackson in the Times again just yesterday promotin...
By IanMK13 , 8 hours ago
-
RE: Aira Heat Pump: Stylish Scandinavian Heating
Yeah we have a 40l buffer too. Problem is the App doesn...
By MikeH , 9 hours ago
-
Hi, has anybody got a step-by-step installation guide t...
By Potatoman , 12 hours ago
-
RE: Mitsubishi Ecodan 8.5kW Monobloc (FTC5) Defrost Mode
@gary no set backs. Yes see others in various forums ha...
By AlsoCold123456 , 12 hours ago
-
Looking for homeowner to join our podcast as a guest
We’re looking for a homeowner to join us on the Homeown...
By Mars , 17 hours ago
-
Our system is open no hydraulic separation. The volume ...
By Judith , 18 hours ago
-
RE: Mitsubishi Ecodan ASHP general set-up and efficiency
@gary Morning, yes, both of these are set to 3 on physi...
By ngillam , 19 hours ago
-
If the insulation isn’t wet you can over-cover it. It’s...
By Judith , 1 day ago
-
RE: Is My Midea Heat Pump Inherently Defective?
Sadly I think you are right, until someone develops a c...
By JamesPa , 1 day ago
-
RE: How much radiator capacity do I need for an air source heat pump?
Follow-up: it occurs to me that the difference between ...
By Simonwhiteley , 1 day ago
-
RE: The Definitive Guide to Weather Compensation and Curves for Air Source Heat Pumps
@judith thanks…. Every day a school day. tomorrows le...
By SUNandAIR , 1 day ago
-
RE: The good, the bad and the not that great – my heat pump installation
at the bottom of our installers invoice it said we were...
By NetDonkey , 2 days ago
Latest Topics
-
By Potatoman 12 hours ago
-
By DavidAlgarve 1 day ago
-
ASHP for small garage and workshop
By BobTSkutter 1 day ago
-
By ChandyKris 3 days ago
-
Nibe heatpump comms error when freezing
By Toody 3 days ago
-
Is this normal behaviour for my samsung ashp
By wawyed 4 days ago
-
Can you work an ASHP too hard?
By Simonwhiteley 4 days ago
-
By IRMartini 5 days ago