Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: May 19, 2026
@johnd, sorry just got a bit more info to share with you. Spoken with the Peak engineer yesterday and it was him manually adjusting the FT on our sy...
@jamespa and @johnd we had 2 engineers out today from Peak to review the ASHP. They’ve given the external unit a good once over and checked the firm...
@jamespa @johnd just spoken with our installer who also had no response from Peak. I've asked to chase up the WC issue again. Also requested the ...
@jamespa the compressor does run at max operating frequency in these lower temperatures (2 degrees and below) and doesn’t seem to have any opportunity...
Forum Handle: @davec Manufacturer: Peak Energy Model: 11kW V-Therm S-Maxi Type: ASHP Arrangement: Monobloc Area of Country: North West Engla...
@jamespa system design was for 40 degrees FT at -2 degrees OAT. We’ve 11x triple radiators and 2x towel rails in bathroom and downstairs W/C
@jamespa external unit details
@jamespa after a bit of homework today I have responses for you; Floor area of 122 m2 Construction, late 1930s, semi detached, brick and cavity wa...
Thanks @jamespa and thanks @johnd (hope I haven’t hijacked your thread too much). I’ll hopefully hear back from our installer or the manufacturer ea...
@jamespa factory menus;
@jamespa pics showing status pages, level 1 parameters and level 2 parameters Software version seems to be dated 2023-03-24 ...
@majordennisbloodnok our swap out install finished around 1pm
SPONSORS
Degrees of Separation
Latest Posts
-
RE: Siting of the external sensor on a heatpump
Of course had the heat source been a heat pump it would...
By JamesPa , 1 hour ago
-
Never assume, it makes an ass of u and me! OK, tha...
By JamesPa , 2 hours ago
-
RE: Recommendations in Ely (Cambs) area for Full setup checks on Nibe HP setup for House.
In fairness all heating has cost a lot to run in recent...
By JamesPa , 4 hours ago
-
RE: Is it the house or the equipment?
@springswood We have two Daikin single split A2A syst...
By Rob of York , 5 hours ago
-
RE: Next steps on my ASHP journey: Radiators and Pipework
You should (almost) always reject having a buffer, by w...
By JamesPa , 1 day ago
-
RE: Navigating the World of Refrigerants In Heat Pumps: A Guide for Homeowners
Indeed we are invvestigating AC at present and are havi...
By Toodles , 1 day ago
-
No, but the heat pump must be capable of delivering a S...
By JamesPa , 2 days ago
-
RE: Daikin ESPAltherma and Home Assistant installation
It's laziness lol The PV system is very chatty, meter...
By bobflux , 2 days ago
-
RE: Problems with sizing a replacement for a Viessmann Vitocal 200-S
R (The R Project for Statistical Computing, I use it wi...
By cathodeRay , 2 days ago
-
RE: Vaillant Arotherm Plus 7KW need a service on it
booked it with Vaillant. will use them until i can find...
By AdamK , 2 days ago
-
RE: Adventures in heat loss calculations
I have seen it stated that the declared calorific value...
By JamesPa , 2 days ago
-
RE: Two heating zones to one zone
@transparent Many thanks. The garage is fairly well ...
By Profzarkov , 3 days ago
-
RE: Vaillant Aurotherm - Heater Wire Position
Ah, good point. I need to check if this was installed i...
By Batpred , 4 days ago
-
@batpred thanks for getting a copy. Appreciate the supp...
By Mars , 4 days ago
SPONSORS
