Activity
 
Notifications
Clear all
Boycey
@boycey
Member
Trusted Member
Joined: Dec 15, 2024
Last seen: Mar 20, 2025
Topics: 2 / Replies: 35
Reply
RE: Ecodan Auto Adapt Questions

@richard24738 just add a length of wire to exsistng one? Would that work, I think it's just transferring the signal from the end sensor. Might be wort...

10 months ago
Reply
RE: Ecodan Auto Adapt Questions

@richard24738 have you popped the cover of to see if there's any length tucked inside, if you (we) could position it nearer the bottom of HP I would t...

10 months ago
Reply
RE: Ecodan - Auto Adapt

@richard24738 if the sun's out, aren't you getting solar gain in the house?. We have the same thing, our HP is on the south side so get sun directly o...

10 months ago
Reply
RE: Ecodan - Auto Adapt

@richard24738 do you know where the outdoor thermistor sits, is it on the back, top corner? Mine sits on a raised balcony but south facing, I'm thinki...

12 months ago
Reply
RE: Ecodan - Auto Adapt

@richard24738 what did mitsu say in the end, did you manage to fix the issue?

12 months ago
Reply
RE: Analysing MELcloud heat pump graphs

@sunandair I meant as I had already mentioned. It was commissioned, I have been l, like most here trying to get it set up efficiently. Ie take the act...

12 months ago
Reply
RE: Analysing MELcloud heat pump graphs

@gary yes pump was on speed 1 for a few days. And yes u I understand what your dying re putting flow rate up. What size HP have you got? UFH ? I just ...

12 months ago
Reply
RE: Analysing MELcloud heat pump graphs

@sunandair stats set as above so there is just one set above bedroom comfort level, so that the circulation pump operates, I will then set that stat t...

12 months ago
Reply
RE: The Definitive Guide to Weather Compensation and Curves for Air Source Heat Pumps

@gary hi, so if your min flow temp is 32c what happens when the weather gets a bit milder, does the house over heat? how do you control the temp in th...

12 months ago
Reply
RE: Analysing MELcloud heat pump graphs

@sunandair hi, its a new system, been in two yrs but not really used whilst it was being sold, i have asked the agents that maybe it should of been se...

12 months ago
Reply
RE: Analysing MELcloud heat pump graphs

@sunandair yes ive done that to check the L/M, and checked quite a bit, seems not to change

12 months ago
Reply
RE: Analysing MELcloud heat pump graphs

@sunandair hi, yeah I've set WC curve to 40c @ -19 and 30c@ 4, it's averaging about 10c oat today. All actuators taken off all stats set to 17c except...

12 months ago
Page 1 / 4
Share:

Join Us!

Latest Posts

Click to access the login or register cheese
x  Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
ShieldPRO