Forums

Forums
Members
Kev M
Activity
 
Notifications
Clear all
Kev M
@kev-m
Member
Famed Member
Joined: Mar 5, 2021
Last seen: Jan 8, 2025
Profile Activity
Topics: 10 / Replies: 1266
AllTopicsReplies
Reply
RE: Ecodan 14kW hot water

Where is your water tank? I'm wondering how it gets so cold, way below room temp. Does it ever actually get to 50 deg at the taps?

1 year ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: 4 Year Ongoing Heat Pump Battle

Wow, quite a saga. Surely the fact that the ASHP could not deliver more than 25 deg flow in colder weather means is has a fault. Your house has almos...

1 year ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Electricity use for heat pumps - comparing homes and consumption

14kW Ecodan, rural East Midlands, largish 1990 bungalow 21.5 throughout mostly 24/7. Heating and HW combined- December 699kWh COP 2.95 January 947kWh...

1 year ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan help with efficiency setup and design - removing manifold mixers, LLH and pumps

Looks good so far. The cycling may be the low flow temps rather than the energy (although they are of course related). Ecodans seem to struggle to m...

1 year ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ground source heat pump is unaffordable to run

@gshpwoes scalding hot DHW suggests it's using an immersion heater. This would use a lot of energy. Does your GSHP also have a backup heater, i.e...

2 years ago
Forum
Grounds Source Heat Pump (GSHPs)
Reply
RE: How are Ecodan CoP quotes from MelCloud setups?

@davidalgarve The figures from the control panel and those from Melcloud should be the same, as yours are. I was talking about using external heat ...

2 years ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: How are Ecodan CoP quotes from MelCloud setups?

I have used both on the same system and the previous internal measurements of COP were very similar to the current externally metered ones.

2 years ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 11.2kW with low 5 litre per minute flow rate leading to L9 error

The high delta T (difference between THW1 and THW2) also supports a too low flow rate. Are all the ufh/radiators all getting warm? Even at an average...

2 years ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Heat pump size advice – is 16kW overkill for this property?

@bontwoody I agree with most of your comments and I especially agree the installer is either making things up or is really incompetent. On the sizi...

2 years ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Heat pump size advice – is 16kW overkill for this property?

I'm not sure about the relevant consumer law. It might be hard to prove it's not fit for purpose if it's able to heat the property and especially if ...

2 years ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Heat pump size advice – is 16kW overkill for this property?

@bontwoody, it does seem excessive for a 100m2 house that has a heat loss in the normal range.

2 years ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Do setbacks save energy without compromising comfort?]#

In the interests of science I'm going to take one for the team and switch to 24 hour operation. I'll then be able to compare with my setback data. I...

2 years ago
Forum
Air Source Heat Pumps (ASHPs)
Page 1 / 107
Share:

Join Us!

RHH Awards

👉 Vote for “Heat Pump of the Year”

👉 Vote for “Best Manufacturer Customer Support”

👉 Nominate “Heat Pump Installation of Year”, “Best New Tech or Innovation” or “Turkey of the Year” here!

Latest Posts

Members Online