Last seen: Apr 12, 2024
@haggistrap I have no idea what the COP is mine does not tell me anywhere. The HP is effectively on most of the time. I only use Heat on Demand for ...
@hcas I use schedules both with the wall stat and TRVs.
@haggistrap Mine is ok until ambient gets down nearer freezing, say sub 4 degrees. Be interesting to hear how yours performs with a full charge of ref...
@toodles Hive is working fine for me after the mods I did. However, I agree it would have been useless without it. Hive do not actually recommend its ...
@haggistrap Those are porky pies. It will not give those outlet temps. I will look through the data sheets I have but I am petty sure they say differe...
@haggistrap Terry, our HP do not run at 70C. 55 is about the max. It will run cooler . Mine is weather dependent and runs between 35 and 50 normally f...
@oswiu have you model before, External unit is EPRA18DAV3, supposedly a 18 kW High Temp Altherma unit. If is installed as per instructions , no stru...
@batalto Thank you, I am well aware of the physics , but you have to make enough heat to warm the house adequately. My present weather compensation is...
@batalto It will not make any difference unless it stops continuous defrosting, or at least significantly extends the interval between defrosts. I can...
@batalto I know and understand what you mean. I am trying to work out what temp I should set for the current ambient, based on what it is reaching on ...
@batalto will reduce further tomorrow, just trying to work out what the mean temperature ( with the HP cycling on and off), is at the moment that is m...
@derek-m yes weather compensated. Will try lower temperatures tomorrow.
- 26 Forums
- 2,199 Topics
- 48.4 K Posts
- 36 Online
- 5,854 Members
Join Us!
Podcast Picks
Latest Posts
-
-
RE: Heat Pump Installers: Competence, Illusion and the Hard Truth Homeowners Must Face
@pirate-rich there’s a lot to do and plan, and the wish...
By Mars , 6 hours ago
-
RE: Why Air Release Valves and Deaerators are Non-Negotiable
@chas-b and @pirate-rich spent the day with us today ta...
By Mars , 6 hours ago
-
RE: Help me keep the faith with my air source heat pump installation
@adamk Its a bit complex: My 28mm primaries run for a...
By JamesPa , 8 hours ago
-
Can you separate out the scop data between hot water an...
By Andrew J H , 10 hours ago
-
RE: Solar Power Output – Let’s Compare Generation Figures
Further, these bar charts may throw a few more lumens o...
By Toodles , 11 hours ago
-
RE: Heat pump and wifi kit connection.
Wi-Fi kit covers any Samsung device that has a modem in...
By Alfapat , 1 day ago
-
RE: How to Understand Wiring Up a Heat Pump
I’m watched @pirate-rich rewire our wiring centre last ...
By Mars , 1 day ago
-
RE: Sizing - Save me from my headache
If you get an R290 pump you should be able to heat the ...
By JamesPa , 1 day ago
-
RE: Large heat pump options for church building
@aventus-eco Thanks Sean, will drop you a line.
By Josephiah , 1 day ago
-
RE: Moving FIT array onto a Tesla Powerwall 3 possible?
@toodles that’s good news for @adamk
By Judith , 1 day ago
-
RE: Samsung Gen 6 - Schedules not working
@technogeek That sounds very logical :-). I will give i...
By bontwoody , 1 day ago
-
RE: Who's your electricity provider and what's your tariff?
Considering Octopus states all their electricity is gre...
By AgentGeorge , 1 day ago
-
RE: Heat Pump + Tado Setup: Smarter Control for Secondary Pumps?
@pirate-rich thanks for the reply. If I were to explo...
By Lloydi , 1 day ago
-
RE: Seal the Deal: Don't Let Your Heat Pump Leak Energy
@transparent I think the committee might get into some ...
By Toodles , 2 days ago
-
Samsung ASHP Support in Midlands area?
Hi all, Per title.... can anyone recommend a ASHP ser...
By Andehh , 2 days ago
-
May I present the maths I referred to earlier when disc...
By Transparent , 2 days ago
-
RE: RDSAP10 effect on existing heat pump EPC rating?
How many times and dates have epc sap rules been change...
By Tim441 , 2 days ago