Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: Sep 11, 2026
@jamespa the only other thing ive wondered is why when the installers guy was fitting the auto air bleed he seemed to curse as if he'd fitted it to th...
@editor yeah i looked at those but id need 12+ for my place which would set me back £330 for the 12 pack. they look like a underfloor flow rate valve ...
ok my setup is pretty simple: 7.35kw cibse heat loss 7kw Vaillant Arotherm Plus no buffers/volumisers 250L Vaillant Heat Pump unistor tank 1...
@heacol maybe you can figure why mines vibrating the primaries in my ceiling when you’ve finished😁. @editor good luck with the repipe, must ...
@jamespa yes I guess. But surely not everyone is buying special anti vibration clips? My plumber (who has worked on large scale renewable stuff in a p...
@jamespa if I remember the insulation has a notch cut in it so it goes over the pipe and either side of the joist.
@jamespa installer said today "Yeah unfortunately thay is not going to help with vibration. They aren't anti vibration clips and/or the pipes been wra...
@jamespa pretty sure, unless the water pump makes a humming noise outside when stood about 2m from the unit. I can hear for instance when it ramps up ...
also if the primaries inside the house are clipped against the ceiling trusses, i have a lowered ceiling so have a void where the pipes run, would it ...
who do i contact about getting stuff sorted when the installer doesnt seem to be doing anything constructive about getting the sparks back to fit the ...
@jamespa the paving slabs are not cemented down just weight of the hp holding everything in place. Hp not fixed to slabs, slabs not fixed to each othe...
@grantmethestrength how did you adjust the pump?
SPONSORS
Degrees of Separation
Latest Posts
-
RE: DIY Heat Pump Installations: Navigating Legal and Regulatory Hurdles
Without doing some research I can't immediately answer ...
By JamesPa , 28 minutes ago
-
RE: How should the Boiler Upgrade Scheme be reformed?
Political suicide given that the vast majority depend o...
By JamesPa , 1 hour ago
-
RE: Replacing Storage Heaters with a Heat Pump in a Stone Cottage
Excellent find, thanks for posting the link here.
By cathodeRay , 6 hours ago
-
RE: Tesla Powerwall (2) Calibration Cycles
For Powerwall calibration, avoid forcing repeated deep ...
By EnergyStorageTech , 7 hours ago
-
Over the years, due to the non barrier PEX underfloor h...
By bobflux , 19 hours ago
-
RE: Getting closer to a finished Haier system
All the 45° elbows required for getting the primaries i...
By Singlespeed , 20 hours ago
-
RE: battery storage without solar
Indeed, current on the grid input = current used for ch...
By bobflux , 2 days ago
-
RE: Who's your electricity provider and what's your tariff?
@papahuhu @papahuhu A lot of tears and sweat went into ...
By Andris , 2 days ago
-
RE: Solar Power Output – Let’s Compare Generation Figures
We have the same problem, 12 mature trees clip the morn...
By Papahuhu , 3 days ago
-
RE: Solis inverters S6-EH1P: pros and cons and battery options
I had a battery and inverter installed a while ago, my ...
By Batpred , 3 days ago
-
RE: Is This Initial Free Quote From Octopus Trusted Partner Reasonable?
@ltron2 The EPC on our house is A-92, however that i...
By Rob of York , 3 days ago
-
RE: Heat pump branding. Clever, contemporary… or a bit too much?
The layout is confusing - much better like this: We b...
By downfield , 4 days ago
-
RE: Is it just me, or does tradesperson timekeeping and communication drive you absolutely mad?
My experience, backed up by opinions from various frien...
By Majordennisbloodnok , 4 days ago
-
RE: Analysis of the economics of switching to an A2W ASHP compared to other heat sources
I had a meeting today with a company based out of Swede...
By Mars , 5 days ago
-
RE: Review your electricity provider
We were with Octopus in our old house and it was fault...
By ian33a , 5 days ago
SPONSORS
