Last seen: Nov 7, 2024
I lowered the temp to 60 (the lowest it will go) for today's cycle. It got to 58 in the expected amount of time, then the element went off and came on...
I have an ASHP, solar and (only) 5.2kWh of battery storage. Last year I was on Cosy when it came out, then switched to Flux, then back to Cosy in Autu...
@transparent Oh right, I'll get all of that insulated as well. They actually left quite a lot in the rubbish pile, which I kept. Out of interest, all ...
Thank you @toodles , I ordered a temperature probe with two clamps and it's taken a while to arrive, I just need some time when the kids are out now s...
@transparent Below the Tundish the pipe goes to the exterior, the 2nd pic shows what is above. They were a bit miserly with insulation, I h...
@transparent It looks like the element is set to it’s maximum. Pretty sure that the grey wire halfway up the tank is a temp sensor right?
@transparent I can see my DHW tank temperature in the MELCloud app, hence why I thought that it would 'know'.
I didn't know that this is the way that it would work, I assumed that the Ecodan would be reading the temperature of the DHW tank and adjust according...
I managed to partially keep an eye on mine today for it's cycle (200L tank btw); 13:27 Tank temp 49.5°C ASHP goes off 3kW load in addition to...
@richard24738 My next L cycle is tomorrow conveniently, I'll try to keep an eye on it to see what it does.
@richard24738 Perhaps I need to re-visit mine for a closer inspection, thanks. I would not be surprised at all if there were gremlins in the Mitsubish...
Latest Posts
-
RE: My misgivings about installing ASHP and solar panels via the ECO4 scheme...
@dwynwen perhaps similar to the environment it'll take ...
By Bart , 50 minutes ago
-
RE: Renewables & Heat Pumps in the News
Here’s a little more technical detail/p>
By Judith , 2 hours ago
-
A good start but I’m glad I didn’t need to learn someth...
By Judith , 2 hours ago
-
RE: Who's your electricity provider and what's your tariff?
I don't (yet), but my PW3 is due to be installed shortl...
By Old_Scientist , 6 hours ago
-
RE: MCS and NAPIT complaints process
@chrislay, is your heat pump complaint still unresolved...
By Mars , 10 hours ago
-
RE: ASHP Install from hell - help please
@saf1973 I’ve been going through old cases on the forum...
By Mars , 10 hours ago
-
RE: Getting the best out of a heat pump - is Homely a possible answer?
@benson I have gone down the Home Assistant and wavesha...
By Grantmethestrength , 21 hours ago
-
RE: RDSAP10 effect on existing heat pump EPC rating?
@aaron There's the rub, the database does not list my ...
By AF1 , 22 hours ago
-
RE: Renewable Heating Hub Homeowners' Q&A Podcast
@editor excellent news, congratulations and well deserv...
By ASHP-BOBBA , 23 hours ago
-
RE: Vaillant AroTherm Plus 7kW
Depends on the flow temperature; the Czech data sheet i...
By JamesPa , 1 day ago
-
RE: Commencing on an ASHP Installation Process
Yes, it's "doable" if everything goes to plan, they arr...
By Old_Scientist , 2 days ago
-
RE: How not to install a heat pump
You are right. Thinking on this has evolved over the p...
By JamesPa , 3 days ago
-
RE: DHW SET UP with Samsung gen 5
Thats good news indeed, you are very likely almost ther...
By JamesPa , 3 days ago
-
RE: Plate heat exchanger considerations
As far as I can tell my vented system would have a peak...
By Scalextrix , 3 days ago
-
RE: Air Changes per Hour - ACH and the MCS requirement
There have been a few discussions dotted around (e.g. I...
By Declan90 , 3 days ago
-
RE: Heat Pump Servicing & Maintenance – Good Value or Rip-Off?
Having made some enquiries locally I have found a compa...
By Morgan , 3 days ago
