Joining the Renewable Heating Hub forums is completely free and only takes a minute. By registering you’ll be able to ask questions, join discussions, follow topics you’re interested in, bookmark useful threads and receive notifications when someone replies. Non-registered members also do not have access to our AI features. When choosing your username, please note that it cannot be changed later, so we recommend avoiding brand or product names. Before registering, please take a moment to read the Forum Rules & Terms of Use so we can keep the community helpful, respectful and informative for everyone. Thanks for joining!
Last seen: Apr 14, 2024
I also have the WPL25. I find the Steibel Eltron Portal very, very basic. So I also run a Home Assistance Green Pi, which gives me far better ...
@transparent the Heat Pump installer was Renewable Heating Wales. I would strongly recommend them. The solar and batteries were done separately. I n...
@iancalderbank I have absolutely no idea what this means 🙂
@transparent You may have noticed an Immersion heater on the tank? I have Solar and if there's excess, rather than send back to the grid, I can ...
@transparent Self install? lol. The unit is outside an outhouse, which houses the "plant room" with all the "gubbins" self install? I...
@transparent after your post I had to go check! I took a vent off the wall to take a look. I was wrong, the double is on the inside, single outsid...
Laminate is floating. Didn’t even know that bonding to the screed would increase heat transfer!
@transparent so the old flooring came out, down about 8 inches, I think. Then 4 inches of insulation went down, foil side up. The underfloor hea...
@editor the main living room is approx 30m2 with a design temp of 21 degrees at 74w/m2 for a total of 2,264. No idea how that compares to anyone else!...
@editor Steibel replaced an old gas boiler. When we bought house, boiler needed replacing. We wanted all the radiators gone off kitchen walls, so w...
@transparent so its weird construction. Double engineering brick outer wall and single skin inner wall. Our buyers inspection engineer said the wall...
- 27 Forums
- 2,768 Topics
- 65.2 K Posts
- 1,066 Online
- 7,169 Members
Join Us!
Installer Finder
Degrees of Separation
Latest Posts
-
We kept ours and Heat Geek would have been in touch if ...
By Batpred , 5 hours ago
-
RE: Who's your electricity provider and what's your tariff?
Hope you are hearing from a good source? Call me old ...
By Batpred , 5 hours ago
-
RE: Missing flow temperature in Heat Geek proposal
The Heat geek contract had various get-out clauses with...
By Batpred , 7 hours ago
-
RE: Why are ASHP installs so expensive?
It seems a quite comprehensive breakdown. I will try to...
By Batpred , 7 hours ago
-
RE: Starting Our Heat Pump Journey: 1962 build 3 bed detached house
@ian-s I would encourage you to have a conversation ...
By Rob of York , 13 hours ago
-
RE: Is it the house or the equipment?
Thanks @jamespa The last hard to fix draughts in the...
By springswood , 14 hours ago
-
RE: Vaillant Arotherm – Using Heating
@l8again Mine is typically using 11w including the i...
By Batpred , 16 hours ago
-
RE: Next steps on my ASHP journey: Radiators and Pipework
If you have a flowmeter and two temperature probes, the...
By bobflux , 1 day ago
-
RE: Siting of the external sensor on a heatpump
@jamespa Absolutely. Even if the same mistake was mad...
By Batpred , 1 day ago
-
-
RE: Recommendations in Ely (Cambs) area for Full setup checks on Nibe HP setup for House.
In fairness all heating has cost a lot to run in recent...
By JamesPa , 2 days ago
-
RE: Navigating the World of Refrigerants In Heat Pumps: A Guide for Homeowners
Indeed we are invvestigating AC at present and are havi...
By Toodles , 3 days ago
-
RE: Daikin ESPAltherma and Home Assistant installation
It's laziness lol The PV system is very chatty, meter...
By bobflux , 4 days ago
-
RE: Problems with sizing a replacement for a Viessmann Vitocal 200-S
R (The R Project for Statistical Computing, I use it wi...
By cathodeRay , 4 days ago


