Last seen: Nov 18, 2025
I agree, and in the main thread with the data I have been careful to point out this is a very limited data set, less than a week, with nothing excepti...
Actually, we do know the LWT and RWT when the heat pump is off, see my charts, and so can estimate the radiator temp, say an average of the LWT and RW...
@derek-m and @jamespa - it might help if I clarify how I do the calculations. The minute data has amps, volts, LWT, RWT and flow rate. I have assume...
Have a look at my recent postings showing observed energy use with a setback and an assessment of energy saved. There is a small amount of whatiffery ...
@mike-h - the key thing is that standard weather compensation for most heat pumps only takes account of the outside air temperature, and sets the LWT ...
Depends what you mean by cheap, but the short answer for most people is no. Energy in isn't that complicated, but energy out is, as is the monitoring ...
Same here when it gets below to around 5 degrees and below, which is why I am surprised I didn't have any defrost cycles last night. Surely that ...
The coldest night of this heating season so far, briefly got down to 2 degrees outside and 16.4 inside, but by 0712 hours the IAT was back to 18 degre...
I finally found something in the minimalmodbus manual on how to read individual bits from a 16 bit register: Reading individual bits from a 16-bit...
@derek-m - thanks. There are lots of versions of this table around, and they are all slightly different. Here's a scan of the same part of the table f...
@derek-m - I am very wary of writing to any register until I am absolutely sure what I am writing to, hence the attempts to reliably read the data bef...
@derek-m - I agree, see above, the efficiency loss caused by raising the LWT matters, but I still think empirical data is the best way to determine ho...
- 26 Forums
- 2,289 Topics
- 51.4 K Posts
- 537 Online
- 5,949 Members
Join Us!
Podcast Picks
Latest Posts
-
RE: Electricity price predictions
The plan is not to switch off for extended periods. Al...
By Jeff , 3 minutes ago
-
RE: Octopus Cosy Heat Pump Owners & Discussion Thread
The problem comes only if you can't turn the ft down su...
By JamesPa , 13 minutes ago
-
RE: Installer Fitted 9kW Instead of 11kW Heat Pump and Changed MCS Paperwork - What do I do?
@jamespa Yes, the OAT sensor is situated on the back pa...
By Toodles , 2 hours ago
-
RE: DHW heat loss through pumps.
Ah, you have a water circulation loop, (like in hotels)...
By JamesPa , 2 hours ago
-
RE: Ecodan ASHP Low COP and Unstable Compressor Frequency
Just to clarify, returning water from UFH is colder tha...
By lukewarmbath , 2 hours ago
-
RE: 10kw heat pump run in 24*7 data?
A different heat pump (Midea 14kW) but a stark reminder...
By cathodeRay , 2 hours ago
-
From what I see, the work to upgrade the cable, etc all...
By Batpred , 2 hours ago
-
RE: Confusion over Octopus Tariffs
That's sounds great. I have no ASHP, but 15kwh storage....
By Batpred , 3 hours ago
-
RE: Solis S6-EH1P8K-L-PLUS – Why I Chose It and What I’ve Learned So Far
Locked environments are difficult to manage, it also me...
By Batpred , 3 hours ago
-
RE: Do Heat Pumps need to start up at Full Power?
@steelbadger Attached is the plot for various parameter...
By Toodles , 7 hours ago
-
RE: Has anyone seen this problem before? Huge anticycling times
Hi all, I had a 15kw installed 3 weeks ago. The past we...
By jamesh , 8 hours ago
-
Adia Therma - 'autopilot for heat pumps'
Thought I'd pop this one in here as the Adia proposal a...
By seatonian , 22 hours ago
-
RE: Mitsubishi Ecodan R290 10kW performance
Don't know answer to final question. Your contract p...
By JamesPa , 22 hours ago
-
RE: New Fogstar 15.5kWh upright solution
Ah, it seems PACE BMS are easy to source on AliExpress,...
By Batpred , 23 hours ago
-
RE: Vaillant water pressure gauge vs Analogue gauge
@jamespa Agreed I don't feel concerned about this, espe...
By jeegnesh , 1 day ago
-
RE: Heat Pumps Without Grants: Would You Have Installed One & Will You Now?
@toodles Yep, and it is not even a sticking plaster ...
By Jeff , 1 day ago
-
RE: Renewables & Heat Pumps in the News
I agree, imperfect systems like voting for politicians ...
By Batpred , 1 day ago
-
RE: Gov wants to alter our FIT contracts from rpi to cpi
The consultation is just part of the normal process for...
By Jeff , 1 day ago
-
@transparent @old_scientist Quick update, I submitted...
By Batpred , 2 days ago


