Forums

Forums
Renewable Heating
Air Source Heat Pum...
How loud are the so...
 
Notifications
Clear all

How loud are the sound levels of internal components like water heater, buffer tank, etc. in an air source heat pump set up?

 
Page 1 / 3
Air Source Heat Pumps (ASHPs)
Last Post by Toodles 9 months ago
36 Posts
11 Users
7 Reactions
3,506 Views
RSS
 Ollie
(@ollie)
Active Member Member
Joined: 11 months ago
Posts: 3
Topic starter 11/09/2024 4:12 pm  

I'm going through the process of an air source heat pump install with Aira. The indoor components I've been recommended are their 250L water heater and 40L buffer tank. They won't fit in the space of my current system 80L immersion. For various reasons the most attractive location to me for the new kit is in the master bedroom (boxed in with sound proofing) but I can't find anywhere any notes on sound levels of the water heaters or buffer tanks of any system, Aira or otherwise.

Could people here with a heat pump advise how loud the internal components (e.g. water heater, buffer tank) of a heat are?

Thanks in advance 

 

This topic was modified 11 months ago by Mars

   
Quote
Toodles
 Toodles
(@toodles)
Illustrious Member Contributor
Joined: 3 years ago
Posts: 2011
11/09/2024 4:33 pm  

Is the Aira range available as a monobloc design? (i.e., most of the ‘gubbins’ are within the unit that lives outside) Our Daikin is of the monobloc design so there is very little to cause noise indoors; admittedly we don’t have a conventional DHW tank as we had insufficient space to accommodate more than the existing 99 litre tank so have a Sunamp Thermino ePC210 which runs silently. Our secondary pump is almost silent and with the airing cupboard doors shut, we cannot hear any sound. The pump is a Wilo Pico and runs at a consumption of ~7-9 watts. I don’t suppose any of this is relevant to an Aira system, but I do try!😉 Regards, Toodles.

This post was modified 11 months ago by Toodles

Toodles, he heats his home with cold draughts and cooks his food with magnets.


   
ReplyQuote
 Ollie
(@ollie)
Active Member Member
Joined: 11 months ago
Posts: 3
Topic starter 11/09/2024 4:51 pm  

Thanks @toodles. Just checked and it is indeed a monobloc design. It makes sense to me that the components I'm talking about wouldn't make a lot of noise - as far as I can tell the indoor unit is similar to an unvented hot water cylinder. Useful info that your setup is low noise


   
ReplyQuote



 IvanOpinion
(@ivanopinion)
Estimable Member Member
Joined: 1 year ago
Posts: 72
11/09/2024 5:11 pm  

I haven't heard any discernible noise from the internal parts of my system, which is a Vaillant. Admittedly, I have no buffer, but I doubt they are noisier. And so far, no noise from radiators and pipes expanding, though perhaps when the water is hotter in winter there will be some expansion noises.

The Aira model is a monobloc, so should be similar. 


   
👍
1
ReplyQuote
Toodles
 Toodles
(@toodles)
Illustrious Member Contributor
Joined: 3 years ago
Posts: 2011
11/09/2024 5:16 pm  

@ivanopinion We used to experience expansion / contraction noises and to a lesser extent, the sound of water coursing through the pipes when we had a gas boiler based system. With the lower temperatures used in our ASHP system, we do not hear either noise source now. The system is blissfully silent - and we love it! Regards, Toodles.

Toodles, he heats his home with cold draughts and cooks his food with magnets.


   
ReplyQuote
 IvanOpinion
(@ivanopinion)
Estimable Member Member
Joined: 1 year ago
Posts: 72
11/09/2024 5:31 pm  

The biggest noise impact is that some of our toilet cisterns are noisy when they fill, due to the water being at mains pressure.


   
ReplyQuote
 Anonymous 5011
(@Anonymous 5011)
Noble Member
Joined: 2 years ago
Posts: 563
11/09/2024 7:04 pm  

Posted by: @ollie
↑

40L buffer tank

Ask why you need it? You should be running an open system, so just one zone, so no need. No buffer means no secondary internal pump, which could add noise.

Our is completely silent.

Would I install any of it in my bedroom - no chance. 

Can you do loft for cylinder? Could be horizontal or vertical. Can you put it in an insulated shed outside?

 


   
👍
1
ReplyQuote
 Ollie
(@ollie)
Active Member Member
Joined: 11 months ago
Posts: 3
Topic starter 12/09/2024 9:12 pm  

Thanks all, very helpful. @johnmo loft would be first choice but because the tank is nearly 400kg when full I'd have to get a structural engineer involved, they'd also need to get the empty tank up there which would at minimum require a bigger loft hatch. Shed outside was also an option but I'd have to run the pipes for some distance outdoors which would be a problem in itself. 


   
ReplyQuote
Mars
 Mars
(@editor)
Illustrious Member Admin
Joined: 4 years ago
Posts: 3366
12/09/2024 10:01 pm  

@ollie, @johnmo raises a valid point about buffer tanks, as they can require additional distribution pumps. While it hasn’t been problematic or particularly annoying for us, I know it’s been incredibly frustrating for others, with noise keeping them up at night. The biggest noise we’ve noticed from internal components definitely comes from the distribution pumps that drive the system’s flow. They emit a low hum, and depending on where they’re located in the house, they can be quite distracting.

Buy Bodge Buster – Homeowner Air Source Heat Pump Installation Guide: https://amzn.to/3NVndlU
From Zero to Heat Pump Hero: https://amzn.to/4bWkPFb

Subscribe and follow our Homeowners’ Q&A heat pump podcast


   
ReplyQuote



 Anonymous 5011
(@Anonymous 5011)
Noble Member
Joined: 2 years ago
Posts: 563
13/09/2024 8:03 am  

The other alternative for a cylinder is the heat geek mini store cylinder 

https://newarkcylinders.co.uk/heatgeekministore/?srsltid=AfmBOorOWI5e6YgVCAplStJUFuTI_zPqwH3sP3AKcBCL-OOaVIklqnIq


   
ReplyQuote
 Derek M
(@derek-m)
Illustrious Member Member
Joined: 4 years ago
Posts: 4427
13/09/2024 11:10 am  

@johnmo

The Mini Stores look great and would appear to be the solution to a problem, but would they get past the MCS criteria?


   
ReplyQuote
 Judith
(@judith)
Prominent Member Member
Joined: 2 years ago
Posts: 368
13/09/2024 8:06 pm  

Our old gas system used to wake OH when the heating came on, partly through valves for the hot water coming on and partly through radiator creaking noises as they warmed. For a full year we’ve run the gas central  heating low and continuously so that did  anyway with the creaking. The airing cupboard is in the bedroom and it still has the change over valve in it so it should be no worse.

2kW + Growatt & 4kW +Sunnyboy PV on south-facing roof Solar thermal. 9.5kWh Givenergy battery with AC3. MVHR. Vaillant 7kW ASHP (very pleased with it) open system operating on WC


   
ReplyQuote
Page 1 / 3
Forum Jump:
  Previous Topic
Next Topic  



Share:

Join Us!

RHH Awards

👉 Vote for “Heat Pump of the Year”

👉 Vote for “Best Manufacturer Customer Support”

👉 Nominate “Heat Pump Installation of Year”, “Best New Tech or Innovation” or “Turkey of the Year” here!

Latest Posts

Members Online