Last seen: Dec 1, 2023
@mikefl @mab, if it helps at all, here's today's data on my Grant 17kW model. The defrost cycles are depicted by the cliff edge drops in the flow temp...
@shapingstuff Here's the electric consumption Vs heat generation of my Grant 17kW unit - EmonCMS link. I used a emonTX with CT clamps to measure ...
I would say you are looking for a controller like pictured in @allyfish 's post here:/p> Or the controller to the right of the picture here:/p> ...
The warmup device is usually for the mat type electric underfloor heating, commonly found in bathrooms.
On most installations the Grant controller is just used to configure the system and external controls are fitted to demand heating and hot water. ...
It is more efficient in the long run as you want the flow temperature to be as low as possible while keeping the house warm, with the heat pump runnin...
Was this a zone on the EvoHome system or just had water flowing when one of the zones was calling for heat? If you can get the heat pump running...
@sirpatchuk1980 I had EvoHome in my last house, a great (if expensive!) setup that did work on my gas boiler. I would not use it on my heat pump tho...
@robl thank you. It's definitely the complete circuit (DHW out and around to the DHW return) - exasperated by the Mixergy technology with their pump o...
Sorry for the delay, notifications for this forum go to my spam folder. The installer I used suggested fitting a motorised valve, linked to the same...
@webcmg From the pictures on your first post it appears that the DHW outlet and secondary return inlet are piped straight up into your ceiling ...
@kk_777 don't worry, I hadn't heard about thermosiphoning either until I started looking in to why the tank heat loss was so great. As for the tank ...
Latest Posts
-
RE: Compressor attempts start but fails - Nibe Fighter 2005 8kW
@jamespa Thank you! As soon as it stops raining I will ...
By skyefarmer , 1 hour ago
-
@heacol, if you're around, can you please provide some ...
By Mars , 3 hours ago
-
RE: Servicing Hitachi HP in rural Somerset
I'd give GreenGenUK a call or email them: sales@greenge...
By Mars , 3 hours ago
-
RE: Ecodan consuming 100kwh per day in new build!!!
@anca1808 I have just reviewed the whole thread. In s...
By JamesPa , 5 hours ago
-
RE: Heating coming on when not required
I played with a max heating temp but there is a world o...
By JamesPa , 16 hours ago
-
RE: Pressure drop Primary circuit
I've always regarded topping up heating systems as my j...
By JamesPa , 16 hours ago
-
RE: Heat pump solutions and/or installer recommendations for France
I’d travel to France for work if you were struggling wi...
By Damon Blakemore , 23 hours ago
-
RE: 5 Star Service from Havenwise
That's always a danger with any new good idea, @morgan....
By Majordennisbloodnok , 1 day ago
-
Have your say in the Renewable Heating Hub Awards
It’s time to celebrate the best (and call out the worst...
By Mars , 2 days ago
-
-
RE: Mitsubishi cycling while on chilled water output
@iaack yes there's no denying that cold air sinks! I s...
By downfield , 2 days ago
-
RE: Weather compensated secondary circuits with Biomass
@andycoo that flooring sounds ideal. Extra volume is ...
By Sune , 2 days ago
-
If you are thinking of heating on the immersion conside...
By JamesPa , 3 days ago
-
RE: Surface mount or bury primaries for heat pump installation?
@tomasmcguinness, I think your best bet would be using ...
By Aventus Eco , 4 days ago
-
RE: Solar Power Output – Let’s Compare Generation Figures
@toodles all depends on asking the right questions! And...
By Tim441 , 4 days ago
-
RE: Commencing on an ASHP Installation Process
I received confirmation this morning that my Greener Ho...
By Sheriff Fatman , 4 days ago
