Last seen: Oct 14, 2024
@derek-m yes I understand. I don't actually switch it off - the temp room controllers will call for heat depending on the set temp - so I may just le...
@derek-m Hi - when you say set the WC offset to zero - do you mean on the control panel - it is currently +0 - I'm right in saying that if my WC is 45...
@gary Interestingly the living area got up to 17 degrees this evening. I think I just need to increase the flow - I'll see how it goes tomorrow - I c...
@gary OK - so I changed the lower temp to 4 and comes back as 36 (picture attached). I increased the flow temp to 45 degrees (from 40) this morning -...
@gary OK - so the actual controller which is next to the tank in a separate room - 15 degrees would be about right. Attached a reading from just now
@gary hi - attached picture of thermistor readings...am I right i n saying that TH1A is the room temp reading - not sure where that is set? THW1 ...
@gary its set to 5
I will post some photos later - I've got to go to work now - thanks.
@derek-m yes not too technical - at least for heating systems!!! I'm having to learn about it though. Yes three thermostats in each room (they are a...
@skd Hi - yes that does! I put on the compensation curve in March and hadn't looked since and when I saw yesterday thought I had not done it properly...
I have also (last night) changed the comp curve to 45 (from 40) - it's not too warm outside today - so I will see if that makes a difference. I've ne...
@gary picture of flow rate
Latest Posts
-
RE: Octopus Cosy 12 Heat Pump Regret: Incredibly Loud, Poor Heating & Constant Hum - Help!
So, after much anguish, and even visiting the neighbour...
By razz , 4 hours ago
-
MLCP (Multi-Layer Composite Pipe) for ASHP
@editor nope. The info you reported was sufficient for ...
By iotum , 6 hours ago
-
RE: Advice for a novice on Mitsubishi Ecodan 6kW
@robs Quick response while I'm in stationary traffic le...
By Sheriff Fatman , 7 hours ago
-
RE: Setback savings - fact or fiction?
Maths looks right to me, my only question about this ca...
By JamesPa , 7 hours ago
-
RE: Ideal HP290 14kW ASHP - how to optimise
@jamespa I wasn’t offended at all. You are very knowled...
By Davesoa , 7 hours ago
-
RE: Experience - New Build / Complete New Heating System
@vincro I would be surprised if it is much above 5 to 6...
By ASHP-BOBBA , 8 hours ago
-
RE: Recommended home battery inverters + regulatory matters - help requested
Yes, certainly not enough could have been tested in any...
By Batpred , 8 hours ago
-
RE: Post-Traumatic Heat Pump Stress Disorder
Yes bang on and maybe I can illustrate that by way of e...
By iotum , 10 hours ago
-
-
RE: Replacing my 18 month old Hitachi Yutaki ASHP
A big thank you to @jamespa for all his efforts online ...
By trebor12345 , 13 hours ago
-
RE: GSHP WOES! Midland based engineer recommendations?
@editor It is indeed for servicing. My current service ...
By Morgan , 14 hours ago
-
RE: Sunsynk Whole House Backup Issue
Hi @lostandconfused , I agree that topic/thread is the ...
By Batpred , 14 hours ago
-
RE: Speedcomfort radiator fans
In case it helps Andrew Kuhne on openenergy monitor has...
By JamesPa , 15 hours ago
-
Things have gone quiet with you @drei. Any updates?
By Mars , 18 hours ago
-
RE: Passiv Smart Thermostat - Help & Forum Support
Thanks @tim441. Interesting timing, as Passiv are a cur...
By Mars , 19 hours ago
-
Hi everyone, I have a two year old Marlec Solar iBoos...
By Tallmarc , 22 hours ago
-
RE: Please help with the settings ecodan
Are you trying to address any particular performance is...
By Sheriff Fatman , 1 day ago
-
RE: Solis inverters S6-EH1P: pros and cons and battery options
🤣 Well, I never managed to get the HA solis "...
By Batpred , 1 day ago
