Last seen: Sep 19, 2024
@cathoderay I am sorry to hear that your heat pump is struggling, though the humidity is allegedly lower today which may help.
@cathoderay Dates and times are important otherwise we may be comparing apples with oranges. Could you please remind me how you arrived at the 1.1...
@jamespa I had arrived at the same conclusion, but did not make comment since I did not wish to influence others. From the table that I published,...
@cathoderay Could you please provide all the relevant data and information in a timely manner, so that a correct peer review of your suggestions can...
@cathoderay Could you please confirm the source of the data in the columns headed 'energy_in' and 'energy_out'.
@cathoderay Could you please provide a copy of the data that you used to produce the most recent charts.
@cathoderay Is there a particular reason why you keep changing the start time for the 24 hour test periods?
@sunandair I thought that when operating in WC mode, the LWT was the parameter being adjusted. Do you have charts for the LWT and RWT?
@sunandair The reheat at 2am occurred because the OAT was lower last night, so the IAT fell at a faster rate and reached the set room temperature at...
@sunandair How are you achieving the lowering of the set room temperature?
I would respectfully suggest that rather than the V x I x Correction Factor, a more suitable equation would be:- Input Power = V x I + Auxiliary Pow...
Below is some information that all you budding statisticians may find of use. The table shows a comparison of the 1.18 correction factor against OAT...
Latest Posts
-
Sadly, no, @agentgeorge. The inverter will handle 5kW t...
By Majordennisbloodnok , 1 hour ago
-
RE: New Fogstar 15.5kWh upright solution
@transparent The readings are 0 for amps, 0 ...
By Batpred , 1 hour ago
-
RE: Say hello and introduce yourself
@velcro welcome to the forums. Please feel free start a...
By Mars , 2 hours ago
-
RE: Speedcomfort radiator fans
I watched the video to see whether they'd potentially b...
By Sheriff Fatman , 2 hours ago
-
RE: Mitsubishi Ecodan R290 10kW performance
@ecoste For what it's worth, this is my equivalent data...
By Sheriff Fatman , 3 hours ago
-
Daikin EDLA11D3V3 DHW Settings
I have a newly installed EDLA11D3V3 which I'm still get...
By Velcro , 3 hours ago
-
RE: Setback savings - fact or fiction?
Will come back to the above points, but for now, I've j...
By cathodeRay , 3 hours ago
-
@jamespa I have found that it comes as a shock when we ...
By Toodles , 5 hours ago
-
RE: My Powerwall 3 Consumes 3-4 kWh/Day in Self-Consumption: Is This Normal?
I suspect a good chunk of the "losses" are power consum...
By Bash , 6 hours ago
-
RE: Need Help Optimising My Rushed ECO4 Install: 12kW Bosch Heat Pump
Hi @mickamills . Welcome to the forum. It sounds like...
By bontwoody , 7 hours ago
-
RE: Midea ASHP – how to set weather compensation
@curlykatie did you get sorted with this?
By MickaMills , 7 hours ago
-
RE: External pipework insulation
@transparent I hope you are not being admonished @trans...
By Toodles , 7 hours ago
-
RE: Octopus Cosy Heat Pump Owners & Discussion Thread
The FT levels off at either the set point OR the minimu...
By AndrewJ , 1 day ago
-
RE: MyVaillant Connect Regular Disconnect
Thanks. Yes, if the time is consistently 11pm every nig...
By buckwem , 1 day ago
-
RE: Who's your electricity provider and what's your tariff?
@transparent Thanks, this helps. Could it be that St...
By Batpred , 1 day ago
-
RE: Clivet ASHPs and weather compensation
Simon did share a lot of very helpful advice. On furthe...
By ambris , 1 day ago
-
-
RE: Advice on internal circulation pump noise
Extend the primary branch and make sure you have more t...
By ASHP-BOBBA , 2 days ago
