Last seen: Dec 3, 2023
I have been pondering whether this is the best way to run my system - us the thermosat just as an "on/off switch", set to an impractically high value ...
Just adding in my details here, or as much as I can remember/look up! Forum Handle: Bob77 Manufacturer: Daikin Model: Altherma 3 R F, 8 kW (ERGA...
I was looking at the Agile Octopus tariff. With underfloor heating it should be possible to get the slab nice and toasty during the cheap overnight pe...
My Daikin Altherma with integrated tank also often shows the water temperature to be below 20C even when there is still hot water coming out. It's not...
What is the size of your house? I have only been collecting numbers for a short while but it looks like my total consumption for December was almost...
Is this different from the “Eco” vs “Comfort” setpoints? My Altherma has two temperature settings, which you can schedule for various times. Eg I ha...
In our recent renovation we put in triple-glazed bifold doors and I have been very impressed. During the recent cold spell there was frost on the outs...
I have a Daikin Altherma LT system and currently the COP is around 2.6-2.7 so it definitely sounds like you have a problem. But having said that, 16kW...
Just to expand on my previous answer, in the recent milder weather with daytime temps of 9-10C and nights staying well above zero the daily usage seem...
I found my Daikin unit coped well with the recent cold spell, even when we had freezing fog the defrost cycles seemed very quick and didn't cause much...
My house is a three-bedroom 1960s end of terrace which we have recently extended on the ground floor. Total area according to the EPC is 117 sq metres...
I have just had my bill for the same period and it was £405. However my electricity usage was around 30% lower than last year, despite the weather bei...
- 26 Forums
- 2,102 Topics
- 46.2 K Posts
- 77 Online
- 3,388 Members
Join Us!
Latest Posts
-
RE: Location of hot water isolation valve on cylinder
@rossowheels if you isolate the water supply in it will...
By ASHP-BOBBA , 2 hours ago
-
RE: Ecodan consuming 100kwh per day in new build!!!
From what you say about the radiators upstairs it does ...
By JamesPa , 8 hours ago
-
RE: Compressor attempts start but fails - Nibe Fighter 2005 8kW
@skyefarmer pleased you found it!
By JamesPa , 9 hours ago
-
The Importance of Radiator Balancing for Efficient Heating: Introducing the Flow Regulating Valve
It’s fascinating to watch how low-temperature heating i...
By Mars , 10 hours ago
-
@heacol, if you're around, can you please provide some ...
By Mars , 13 hours ago
-
RE: Servicing Hitachi HP in rural Somerset
I'd give GreenGenUK a call or email them: sales@greenge...
By Mars , 14 hours ago
-
RE: Heating coming on when not required
I played with a max heating temp but there is a world o...
By JamesPa , 1 day ago
-
RE: Pressure drop Primary circuit
I've always regarded topping up heating systems as my j...
By JamesPa , 1 day ago
-
RE: Heat pump solutions and/or installer recommendations for France
I’d travel to France for work if you were struggling wi...
By Damon Blakemore , 1 day ago
-
RE: 5 Star Service from Havenwise
That's always a danger with any new good idea, @morgan....
By Majordennisbloodnok , 2 days ago
-
Have your say in the Renewable Heating Hub Awards
It’s time to celebrate the best (and call out the worst...
By Mars , 2 days ago
-
-
RE: Mitsubishi cycling while on chilled water output
@iaack yes there's no denying that cold air sinks! I s...
By downfield , 2 days ago
-
RE: Weather compensated secondary circuits with Biomass
@andycoo that flooring sounds ideal. Extra volume is ...
By Sune , 3 days ago
-
If you are thinking of heating on the immersion conside...
By JamesPa , 4 days ago
-
RE: Surface mount or bury primaries for heat pump installation?
@tomasmcguinness, I think your best bet would be using ...
By Aventus Eco , 4 days ago
-
RE: Solar Power Output – Let’s Compare Generation Figures
@toodles all depends on asking the right questions! And...
By Tim441 , 4 days ago
Members Online
No online members at the moment