Last seen: Jan 11, 2026
@heacol maybe you can figure why mines vibrating the primaries in my ceiling when you’ve finished😁. @editor good luck with the repipe, must ...
@jamespa yes I guess. But surely not everyone is buying special anti vibration clips? My plumber (who has worked on large scale renewable stuff in a p...
@jamespa if I remember the insulation has a notch cut in it so it goes over the pipe and either side of the joist.
@jamespa installer said today "Yeah unfortunately thay is not going to help with vibration. They aren't anti vibration clips and/or the pipes been wra...
@jamespa pretty sure, unless the water pump makes a humming noise outside when stood about 2m from the unit. I can hear for instance when it ramps up ...
also if the primaries inside the house are clipped against the ceiling trusses, i have a lowered ceiling so have a void where the pipes run, would it ...
who do i contact about getting stuff sorted when the installer doesnt seem to be doing anything constructive about getting the sparks back to fit the ...
@jamespa the paving slabs are not cemented down just weight of the hp holding everything in place. Hp not fixed to slabs, slabs not fixed to each othe...
@grantmethestrength how did you adjust the pump?
@jamespa just spun it up to do a hot water boost and turned off eco mode. Then I’ve gone round with a cheap stethoscope and can hear it where the prim...
@jamespa this is the third attempt to sort the flexis as the first time they were fitted they were not insulated properly and they changed one when th...
@ashp-bobba yes the flexis are there. they didn’t do a base they just sat it on some paving edging pieces stacked on top of each other then on top o...
- 26 Forums
- 2,406 Topics
- 54.6 K Posts
- 335 Online
- 6,092 Members
Join Us!
Worth Watching
Latest Posts
-
RE: Experience - New Build / Complete New Heating System
@vincro We have a similar sized 1950's semi with a 2...
By Bash , 9 minutes ago
-
RE: Heat loss based on gas usage
@jamespa Thanks. The numbers posted above were jus...
By Bash , 14 minutes ago
-
RE: Heat pump not reaching flow temperature
I would describe this as either a fault or a configurat...
By JamesPa , 50 minutes ago
-
RE: I’m glad the cold spell is over!
Thanks for the update, @judith. Cold spells with heat p...
By Mars , 55 minutes ago
-
RE: Post-Traumatic Heat Pump Stress Disorder
@johnbroome As I say I think you probably have a fau...
By JamesPa , 1 hour ago
-
RE: Solis inverters S6-EH1P: pros and cons and battery options
@batpred I started reading this thread thinking I would...
By Hook , 2 hours ago
-
RE: Please help with the settings ecodan
@sheriff-fatman when I increase it to number 3, the ...
By nose1972 , 3 hours ago
-
RE: Recommended home battery inverters + regulatory matters - help requested
So far as i can see no because its NOT connected to the...
By JamesPa , 3 hours ago
-
RE: New Daikin 11kW Altherma 3M install - is it working as it should?
I forgot to mention: Octopus measured our heat loss at ...
By Toodles , 4 hours ago
-
RE: Considering MLCP (Multi-Layer Composite Pipe) for ASHP
Thanks Mars and thank you for reaching out to so many p...
By iotum , 4 hours ago
-
RE: Air source heat pump roll call – what heat pump brand and model do you have?
Forum Handle: @davec Manufacturer: Peak Energy Mode...
By DaveC , 4 hours ago
-
RE: Rate the quality of your heat pump design and installation
Well, the guy came out, turned the heat pump to max, we...
By razz , 4 hours ago
-
Midea R32 setup and bizarre running with lengthy off periods?
Hi I am new to the world of ASHP and have just had a re...
By Countryman Helmsley , 5 hours ago
-
RE: Setback savings - fact or fiction?
Given the weather has been relatively stable, the empir...
By Batpred , 5 hours ago
-
RE: GSHP WOES! Midland based engineer recommendations?
@editor That is very kind! Thank you so much.
By johnbroome , 6 hours ago
-
RE: ASHP Energy Consumption: Aira 12kW heat pump
@wally Hi I am not sure how large your house is b...
By TechnoGeek , 7 hours ago
-
RE: Predicted Heat Loss & Needs from MCS calcs vs EPC vs actual
I've been thinking along similar lines to @tim441 from ...
By Sheriff Fatman , 8 hours ago
-
Thanks, @technogeek. Good to hear about the accuracy. ...
By Majordennisbloodnok , 8 hours ago
-
RE: Advice for a novice on Mitsubishi Ecodan 6kW
In my case it was a very specific pattern of behaviour ...
By Sheriff Fatman , 8 hours ago
-
RE: Vaillant aroTherm not heating with many faults
@ashp-bobba Yeah I'll give it a go, will check filter...
By Anon67 , 9 hours ago

