Vaillant controls and myVaillant Connect
CEO and co-founder at HavenWise
I messaged a contact at Vaillant who responded to me tonight saying you will need the controller to set the weather compensation curve, set programmes, etc., but you don’t need to use it as an internal thermostat because you can change room control to inactive and it will then run solely on weather compensation.
Buy Bodge Buster – Homeowner Air Source Heat Pump Installation Guide: https://amzn.to/3NVndlU
From Zero to Heat Pump Hero: https://amzn.to/4bWkPFb
Subscribe and follow our Homeowners’ Q&A heat pump podcast
Thanks for checking Mars!
It's strange though, because the Vaillant documentation does say that the Sensocomfort is optional. See illustration on page 6 here. So surely that must mean that I could configure my system via the heat pump control interface module (the VWZ AI)?
And the documentation of the VWZ AI does seem to indicate that I could set a heating curve. See page 19 here.
Could you double check with your contact whether the Vaillant documentation online is just incorrect?
Or whether it's a matter of "you could run your system without Sensocomfort, but we recommend the Sensocomfort on top".
Many thanks!
CEO and co-founder at HavenWise
@hcas, so this is the honest feedback from Vaillant. Technically, yes, you can set the system up without a controller, however, they would strongly advise that you don’t as you would lose the load compensation that you get with the sensoCOMOFRT and the ability to control your hot water system. They don’t ever commission a system in this way or advise doing it, and Vaillant's official stance is you "can’t", but theoretically it can be done.
Let us know how you get along.
Buy Bodge Buster – Homeowner Air Source Heat Pump Installation Guide: https://amzn.to/3NVndlU
From Zero to Heat Pump Hero: https://amzn.to/4bWkPFb
Subscribe and follow our Homeowners’ Q&A heat pump podcast
- 26 Forums
- 2,102 Topics
- 46.2 K Posts
- 53 Online
- 3,388 Members
Join Us!
Latest Posts
-
RE: Compressor attempts start but fails - Nibe Fighter 2005 8kW
@skyefarmer great you located the source of the issue a...
By Mars , 32 minutes ago
-
RE: Location of hot water isolation valve on cylinder
@rossowheels if you isolate the water supply in it will...
By ASHP-BOBBA , 10 hours ago
-
RE: Ecodan consuming 100kwh per day in new build!!!
From what you say about the radiators upstairs it does ...
By JamesPa , 15 hours ago
-
The Importance of Radiator Balancing for Efficient Heating: Introducing the Flow Regulating Valve
It’s fascinating to watch how low-temperature heating i...
By Mars , 18 hours ago
-
@heacol, if you're around, can you please provide some ...
By Mars , 21 hours ago
-
RE: Servicing Hitachi HP in rural Somerset
I'd give GreenGenUK a call or email them: sales@greenge...
By Mars , 21 hours ago
-
RE: Heating coming on when not required
I played with a max heating temp but there is a world o...
By JamesPa , 1 day ago
-
RE: Pressure drop Primary circuit
I've always regarded topping up heating systems as my j...
By JamesPa , 1 day ago
-
RE: Heat pump solutions and/or installer recommendations for France
I’d travel to France for work if you were struggling wi...
By Damon Blakemore , 2 days ago
-
RE: 5 Star Service from Havenwise
That's always a danger with any new good idea, @morgan....
By Majordennisbloodnok , 2 days ago
-
Have your say in the Renewable Heating Hub Awards
It’s time to celebrate the best (and call out the worst...
By Mars , 2 days ago
-
-
RE: Mitsubishi cycling while on chilled water output
@iaack yes there's no denying that cold air sinks! I s...
By downfield , 3 days ago
-
RE: Weather compensated secondary circuits with Biomass
@andycoo that flooring sounds ideal. Extra volume is ...
By Sune , 3 days ago
-
If you are thinking of heating on the immersion conside...
By JamesPa , 4 days ago
-
RE: Surface mount or bury primaries for heat pump installation?
@tomasmcguinness, I think your best bet would be using ...
By Aventus Eco , 4 days ago
-
RE: Solar Power Output – Let’s Compare Generation Figures
@toodles all depends on asking the right questions! And...
By Tim441 , 4 days ago