IVT Greenline multiple alarms
Hi, Newbie here needing help. Initial alarm was CT8 & CT9 at 37C heat pump would run for about 5 minutes. Now multiple alarms CT1 through CT11 HP runs for 5 seconds. Any assistance greatly appreciated. There are more alarm displays but have reached maximum permissible.
I have run some checks. The power supply is good, the refrigerant is clear (not yellow) there is considerable pressure in in the refrigerant citcuit, the Ground Loop Pump works when on separate cable.
Question: Should the Ground Loop Pump come on when the Central Heating Pump comes on? Because it doesn't.
@heacol, do you have any insights or thoughts to answer AF1's question?
Pre-order: The Ultimate Guide to Heat Pumps
Subscribe and follow our Homeowners’ Q&A heat pump podcast
The ground loop pump must run when the heating is on, it may be a connection problem or the board has failed. You can as a temporary measure try connecting the brine pump to a separate source and then run the heat pump.Posted by: @af1I have run some checks. The power supply is good, the refrigerant is clear (not yellow) there is considerable pressure in in the refrigerant circuit, the Ground Loop Pump works when on separate cable.
Question: Should the Ground Loop Pump come on when the Central Heating Pump comes on? Because it doesn't.
Director at Heacol | Expert Heat Pump Consultant | Book a one-to-one consultation for pre- and post-installation advice, troubleshooting and system optimisation.
Posted by: @heacolThe ground loop pump must run when the heating is on, it may be a connection problem or the board has failed. You can as a temporary measure try connecting the brine pump to a separate source and then run the heat pump.Posted by: @af1I have run some checks. The power supply is good, the refrigerant is clear (not yellow) there is considerable pressure in in the refrigerant circuit, the Ground Loop Pump works when on separate cable.
Question: Should the Ground Loop Pump come on when the Central Heating Pump comes on? Because it doesn't.
Thank you Brendon Uys for responding.
Should the Ground Loop Pump (GLP) come on with the other one - i.e. at the same moment?
I didn't think of trying to run the unit when I had the GLP connected to a separate supply - good idea. Should I leave the loom plug disconnected for this test?
The problem I have is that all the alarms now come on almost immediately after the Hot pump starts and lock the unit. Acknowledging the alarms makes no difference.
I could not see how to clear the error log in the manual, do you know please?
If after clearing the alarms the unit works with the GLP on a separate supply, why do you think caused no power to it from te unit?
Hi I was an engineer for ice b4 they went bust that many alarms could possibly be the rego, gt8 and 9 alarms only really an issue once they get 15 degrees apart normally a good service will clean out any magnetite, ice never fitted magnetic filters which all gshp and ashp should have as standard. You can call alto energy basically the ppl from ice who started again without the main director they do a call out service and repair depending where u are in the UK? I'm based Yorkshire and North East
- 26 Forums
- 2,171 Topics
- 47.8 K Posts
- 29 Online
- 5,744 Members
Podcast Picks
Latest Posts
-
WC curve best discovered by experiment anyway as any lo...
By JamesPa , 18 minutes ago
-
RE: Big Changes Coming to Our Heat Pump System
@editor your engineer's attitude is truly horrifying. ...
By GrahamF , 17 hours ago
-
RE: How to choose Towel Rails for an ASHP
@rob-nezard yes absolutely. Here is the link and a pho...
By GrahamF , 19 hours ago
-
@mixergy Thanks for the update, I would appreciate some...
By bontwoody , 21 hours ago
-
RE: Is Your Broadband Router the Weak Link in Your High-Tech Home?
Unfortunately I'm not that well connected 😂 ...
By Scalextrix , 1 day ago
-
RE: A Customer's Lessons Learnt from a Heat Pump Installation in a Large House
It is interesting to see what our new Grant Aerona 290 ...
By GrahamF , 1 day ago
-
RE: Testing new controls/monitoring for Midea Clone ASHP
I've never physically seen it, but I seem to recall som...
By cathodeRay , 1 day ago
-
@jamespa Ours is a Daikin EDLA03 8 kW and the Delta T =...
By Toodles , 1 day ago
-
RE: Midea ASHP – how to set weather compensation
I noticed that too and thought the same thing, but then...
By cathodeRay , 2 days ago
-
RE: Ya can’t win! It is S*d’s Law!
@old_scientist If IOF is still running next late spring...
By Toodles , 2 days ago
-
RE: Electricity price predictions
Those of you on Agile will do well tomorrow; there are ...
By Toodles , 2 days ago
-
RE: Who’s Caved and Switched the Heating On Already?
We've been running our Ecodan system, installed in June...
By Sheriff Fatman , 2 days ago
-
Ok. Two schools of thought. The first is to run the ...
By JamesPa , 3 days ago
-
@drei Willing as I am to help, I don't think I'm yet ...
By JamesPa , 3 days ago
-
Selling 5 year old ASHP & Gas Combi Boiler - £590
Selling a 5-year-old Daikin Altherma Hybrid Air Source ...
By Paul G , 3 days ago
-
RE: Help me keep the faith with my air source heat pump installation
Er true, it should have read l/hr!
By JamesPa , 3 days ago
-
RE: Is a Valliant Inline 6kW heater a BUS buster?
Much of that is true in principle, but its not likely t...
By JamesPa , 5 days ago
-
RE: Heat Pump Servicing & Maintenance – Good Value or Rip-Off?
@dgclimatecontrol I attach the responses from 2 potenti...
By pash44pump , 5 days ago
-
RE: Buffers, hot water and cooling
@dgclimatecontrol thanks, that's helpful.
By JamesPa , 6 days ago