Forums

Forums
Renewable Heating
Air Source Heat Pum...
Flow temperature up...
 
Notifications
Clear all

Flow temperature up and down like a yo-yo

 
Page 2 / 2
Air Source Heat Pumps (ASHPs)
Last Post by zubadanwoes 2 years ago
16 Posts
6 Users
3 Reactions
2,782 Views
RSS
 Derek M
(@derek-m)
Illustrious Member Member
Joined: 4 years ago
Posts: 4427
27/11/2023 3:00 pm  

Posted by: @greekgoddj
↑

@glpinxit yup, that is more of less like what mine looked like last year.. so clearly something has gone wrong at the moment. I am very much looking to get it back into health! 🙂

Have you resolved your problem? Feedback is always welcome.

 


   
ReplyQuote
 greekgoddj
(@greekgoddj)
Trusted Member Member
Joined: 4 years ago
Posts: 20
Topic starter 30/11/2023 10:27 am  

@derek-m No update yet... Still (2 weeks now) waiting for Mitsubishi to send the replacement circulation pump first. Will for sure update this thread when I have an update.

Mitsubishi Ecodan 11.2kW ASHP


   
ReplyQuote
 zubadanwoes
(@zubadanwoes)
New Member Member
Joined: 2 years ago
Posts: 2
05/12/2023 8:34 pm  

@greekgoddj Hello , I am not a plumber just a DIY'er, so any advice is without warranty. Have you checked your exspansion vessel for pre-charge pressure, it should be around 0.3 bar Higher than your cold fill pressure, and if it is holding water on the air side? My ASHP was aggressivley cycling on for 5 minutes, off for two, all the time it was on. I went around the house's with the pump's and system balance but after a year I checked my vessel and the diaphragam had burst , so I got blue coolant come out of the schradder valve. First hook your valve up to a bike/foot pump with a pressure gauge to see what the pre charge is, then you can remove the pump and just touch the middle of the valve for half a second to see if you get water out of the air side.

Hope you get sorted.


   
👍
1
ReplyQuote
 zubadanwoes
(@zubadanwoes)
New Member Member
Joined: 2 years ago
Posts: 2
07/12/2023 2:18 pm  

I forgot to mention, when you are checking your air charge pressure, your water side needs to be decharged ie no pressure, usually bleeding a radiator for ten seconds will do that job, you just need a bucket or pan handy.


   
ReplyQuote
Page 2 / 2
Forum Jump:
  Previous Topic
Next Topic  
Related Topics
Topic Tags:  flow temp (5) , ecodan (30) , mitsubishi (4) ,
Share:

Join Us!

Podcast Picks

Latest Posts

Members Online

Click to access the login or register cheese
x Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
ShieldPRO →