Forums

Forums
Renewable Heating
Air Source Heat Pum...
Ecodan set back
 
Notifications
Clear all

Ecodan set back

 
Air Source Heat Pumps (ASHPs)
Last Post by SUNandAIR 8 months ago
4 Posts
3 Users
1 Reactions
640 Views
RSS
Morgan
 Morgan
(@morgan)
Noble Member Member
Joined: 4 years ago
Posts: 624
Topic starter 02/01/2025 4:51 pm  

Is it possible to schedule a setback temp on the Ecodan whilst in weather compensation?   I have set up a schedule of temp's but they seem not to be enforced.  Must I be in a particular mode to schedule varying temps?


Retrofitted 11.2kw Mitsubishi Ecodan to new radiators commissioned November 2021.
14 x 500w Monocrystalline solar panels.

2 ESS Smile G3 10.1 batteries.
ESS Smile G3 5kw inverter.


   
Quote
Abernyte
 Abernyte
(@abernyte)
Honorable Member Member
Joined: 3 years ago
Posts: 236
02/01/2025 4:58 pm  

Certainly seems to work fine for me in Room Temp mode which is Auto Adapt. Are you using MelCloud - Actions - Timer to programme the set back?



   
ReplyQuote
Morgan
 Morgan
(@morgan)
Noble Member Member
Joined: 4 years ago
Posts: 624
Topic starter 02/01/2025 6:06 pm  

@abernyte  I'm not using Melcloud.  I'm programming the schedule on the main controller.  I may have to switch to AA.


Retrofitted 11.2kw Mitsubishi Ecodan to new radiators commissioned November 2021.
14 x 500w Monocrystalline solar panels.

2 ESS Smile G3 10.1 batteries.
ESS Smile G3 5kw inverter.


   
ReplyQuote
SUNandAIR
 SUNandAIR
(@sunandair)
Noble Member Member
Joined: 3 years ago
Posts: 501
02/01/2025 8:41 pm  

@morgan hi,

We have been using setbacks while using weather compensation. You just set a schedule a little higher than your chosen room temperature. You are relying on the WC CURVE to target your chosen flow temperature. If you’ve set your WC CURVE correctly the temperature will rise only very slowly. It should ideally never reach the  set target room temperature. 

If you schedule a setback then the HP will switch into standby mode until the room temperature drops below the target setback temperature. It will then revert to heating mode until the setback is passed by 1degC.

But as you probably know the FTC screen won’t display a room temperature while in WC mode. We have the Mitsubishi wireless controller and that controller does display the target room temperature and the actual measured room temperature below it.



   
👍
1
ReplyQuote
Forum Jump:
  Previous Topic
Next Topic  



Share:

Join Us!

Podcast Picks

Latest Posts

Click to access the login or register cheese
x Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
ShieldPRO →