Recent Posts
 
Notifications
Clear all

Recent Posts

 |  Forums  |  Topics
Page 97 / 168
Posts with their shortened content
RE: Replacing knackered oil boiler with Samsung ASHP - Perthshire  

By DowallyDrifter, 2 weeks ago

  @dgclimatecontrol thanks for the reply. subesequent reply from Mike_H says legionella cycle is done by the imersion which makes sense to me. Not sure how the existing manifold pump could now be wire...
RE: Effect of Mitsu PAR WT60 Wireless Controller  

By DavidAlgarve, 2 weeks ago

  Hi Rob. Thanks for your comments and I am relieved that I appear to be on the right track. I had to step in and do the PAR WT60 installation myself after my contractor failed to do so and I was rather...
Majordennisbloodnok RE: Getting ready for export  

By Majordennisbloodnok, 2 weeks ago

  Nothing broad about what I’ve posted. My original post simply pointed out that any domestic electrical work (apart from a very few minor exceptions) must be signed off by a qualified electrician. You ...
Jancold RE: Daikin Octopus installation update - I saw my first defrost. 😍😂  

By Jancold, 2 weeks ago

  I don't seem to have a mixer valve. Just pressure regulator. Attachment : PXL_20251021_204934346.jpg  
RE: Getting ready for export  

By Batpred, 2 weeks ago

  If you would be minimally qualified to make these broad statements about electrics, you would have provided the image, the actual quote... As my still unchallenged point was "When stating anything is ...
RE: New Fogstar 15.5kWh upright solution  

By Batpred, 2 weeks ago

  😁Yes, the 90Amps capacity in total in an 8k inverter seemed unbelievable. To get that out of the system, a complex setup is needed. So the smart port is used elsewhere in the english speaking...
Majordennisbloodnok RE: Getting ready for export  

By Majordennisbloodnok, 2 weeks ago

  The KISS principle is about not over-complicating. Following legislated requirements is not over-complicating. I’m glad to read you have, in fact, used a qualified electrician. However your latest rep...
RE: Master & Slave Zones/Setback  

By JamesPa, 2 weeks ago

  Have you yet adjusted the WC settings, it sounds like not. Its difficult to do whilst its so mild, but once adjusted it should be possible to leave. To adjust WC settings (in outline)   Turn al...
Page 97 / 168

 

 

 

Share:

Join Us!

Latest Posts

Click to access the login or register cheese
x  Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
ShieldPRO