Notifications

Clear all

Pallet buster

DIY

Last Post by Mars 3 years ago

8 Posts

5 Users

12 Reactions

2,167 Views

RSS

Majordennisbloodnok

(@majordennisbloodnok)

Famed Member Moderator

Joined: 4 years ago

Posts: 917

Topic starter 16/03/2022 8:54 pm

During the lockdown, wood became ridiculously expensive with everyone turning their hands to a bit of DIY. Even so, I found wooden pallets were still easy to find (once I was allowed out of the house again). As a result, I invested in a bit of kit I’ve subsequently found to be absolutely spot on - a pallet buster.

https://www.screwfix.com/p/roughneck-pallet-buster-demolition-bar-43/6765x

Baically, if you can dismantle a wooden pallet without the wood splitting, it’s amazing how much good construction material it yields. The tool is well recommended by me.

105 m2 bungalow in South East England
Mitsubishi Ecodan 8.5 kW air source heat pump
18 x 360W solar panels
1 x 6 kW GroWatt battery and SPH5000 inverter
1 x Myenergi Zappi
1 x VW ID3
Raised beds for home-grown veg and chickens for eggs

"Semper in excretia; sumus solum profundum variat"

👍

Quote

Anonymous

(@Anonymous)

Joined: 1 second ago

Posts: 0

16/03/2022 10:12 pm

What’s your success rate in not damaging pallets with the buster? I use a chisel and crowbar, with about 40% success.

I just love pallets. Last year I wanted to build more raised beds around the veg garden. Our hardware store, whose prices are very competitive, quoted me around £1,000 for the wood… not a lot of wood I might add. The prices are still insane. The very same hardware store gives away heat treated pallets. I took loads and built four large beds at a cost of £0 for the wood and £40 for liner.

https://myhomefarm.co.uk/raised-beds-from-upcycled-pallets

I’m in the process of building five more (three down, two to go).

👍

ReplyQuote

Majordennisbloodnok

(@majordennisbloodnok)

Famed Member Moderator

Joined: 4 years ago

Posts: 917

Topic starter 17/03/2022 12:26 am

Assuming the pallets are in good condition, I reckon I can dismantle them and reclaim about 85-90%. There are some, of course, that are held together with nails or staples that are complete overkill and success with those is lower, but still immeasurably better than with crowbar, bolster and chisel.

"Semper in excretia; sumus solum profundum variat"

ReplyQuote

Saz

(@saz)

Reputable Member Member

Joined: 4 years ago

Posts: 119

17/03/2022 2:27 pm

What liner do you use for the raised beds @editor? Would ordinary weed control fabric be suitable?

ReplyQuote

Mars

(@editor)

Illustrious Member Admin

Joined: 5 years ago

Posts: 3416

17/03/2022 4:26 pm

@saz, bang on. This is the liner we used, which was excellent, but it's currently out of stock: https://amzn.to/3ijgguF

Pre-order: The Ultimate Guide to Heat Pumps

Subscribe and follow our Homeowners’ Q&A heat pump podcast

👍

ReplyQuote

Mars

(@editor)

Illustrious Member Admin

Joined: 5 years ago

Posts: 3416

17/03/2022 4:28 pm

@majordennisbloodnok, that's an excellent ratio. The issue is pallets that have 3-4 nails in the middle of the length of wood. Those inevitable crack or splinter.

Pre-order: The Ultimate Guide to Heat Pumps

Subscribe and follow our Homeowners’ Q&A heat pump podcast

ReplyQuote

Kev M

(@kev-m)

Famed Member Member

Joined: 5 years ago

Posts: 1276

17/03/2022 4:42 pm

So far I've either used the pallets intact or attacked them with a chainsaw to make kindling. The pallet buster looks good though. This is my latest pallet construction. It's my hedge against increasing energy prices later in the year. Full of free wood. 😀

This post was modified 3 years ago by Kev M

👍

ReplyQuote

Mars

(@editor)

Illustrious Member Admin

Joined: 5 years ago

Posts: 3416

17/03/2022 6:22 pm

@kev-m, that's a neat project. Nice. I've also built four really large wood and kindling containers in our garage using pallets (it was actually my first pallet project) and that too saved a small fortune in wood.

Pre-order: The Ultimate Guide to Heat Pumps

Subscribe and follow our Homeowners’ Q&A heat pump podcast

ReplyQuote