Last seen: Feb 13, 2024
I am not sure what you mean by "now uses timestamps", what did it se before? I expect this comment is because you are not aware of the concept of th...
I think it is disingenuous to not mention all the code that you likely have had to write or hard code to do the following. #1 scale the register val...
I thought I did put enough context in place with my chart - re posted below. I was showing clearly the COP as labelled for short periods of time. I ...
I am taking only the COP during my economy 7 cheap rate - so only first[ish] 7 hours of the day, and switched off the hot water. My hot water COP is ...
The Samsung UI is showing (34/7.4 = COP of 4.60) My data suggests a COP of 5.3. This is about a 15% difference. This could be due to Samsung assumi...
I agree, that it is quite difficult to avoid cycling when the LWT is low. I will continue to persevere though. With [eventually] 8.5 cubic meters of...
Yes, but [samsungs figures] at an ambient of 7 and LWT of 35, that is 10 degrees different to my current setup.
This is the data coming directly out of the Samsung outdoor unit via modbus. So it is as accurate as the Samsung units. There may be some timing iss...
I have been trying to get to the bottom of the occasional cycling of my heat pump. Once my heat pump gets to its lowest modulation level, I actually ...
I am not sure why you would run within a PWM frequency outside the defined operating parameters of the pump. Any particular reason you need 10kHz
I know that if you buy and install a samsung gen 6 kit from midsummer wholesale a PWM pump is specified and documented in the quick start guide. They...
That would be outside the documented specs of the Grundfos by quite a margin. I am surprised it worked.
- 26 Forums
- 2,221 Topics
- 49.3 K Posts
- 223 Online
- 5,881 Members
Join Us!
Podcast Picks
Latest Posts
-
RE: How to increase DHW water temperature on Samsung Gen 6 Control Panel
Im just in the process of connecting up my mixergy cyli...
By bontwoody , 6 seconds ago
-
RE: How good is the app support for your heat pump?
I'm using smarthings for our Samsung 16kw, and it reall...
By DowallyDrifter , 2 hours ago
-
RE: Struggling to get above 3.3 on heating
You should be getting better than that at this time of ...
By JamesPa , 2 hours ago
-
Unless anyone can tell me differently, there appears to...
By DowallyDrifter , 3 hours ago
-
RE: Should Our Water Circulation Pump Be Configured to Run All The Time?
I run my Vaillant on either expanded mode (either end o...
By JamesPa , 5 hours ago
-
RE: Twin 10kw Grant Aerona Volumiser Tanks using lots of power
@adam Hi just jumped on this thread as I too have 2 10k...
By bretix , 14 hours ago
-
RE: Help me keep the faith with my air source heat pump installation
on a facebook thread someone has comented to the effect...
By AdamK , 14 hours ago
-
The timing of training and inference are very applicati...
By wully , 15 hours ago
-
RE: Samsung Heat Pump – Can't Activate TW2 Pipe Sensor (for Delta T Control)
Wanted to add an update. As I am running HomeAssistan...
By bubuontheweb , 17 hours ago
-
RE: Grant 13kW Aerona3 - issues getting zones to temp
You are correct you dont need the second pump if there ...
By JamesPa , 17 hours ago
-
RE: New Fogstar 15.5kWh upright solution
From my experience with inverters from different Far Ea...
By Transparent , 18 hours ago
-
@bontwoody Thank goodness you are ‘back on-line’ so to ...
By Toodles , 19 hours ago
-
RE: Automation options to maximuse efficiency & ToU tariffs
@majordennisbloodnok Seems reasonable. It would be m...
By Batpred , 19 hours ago
-
RE: Havenwise App Help & Forum Support – Get the Most from Your Heat Pump
@hcas OK Thanks. Will do.
By bontwoody , 21 hours ago
-
RE: What crazy nonsense are inverter limits and why are they imposed?
@transparent Thank you for a very comprehensive, tim...
By Batpred , 24 hours ago
-
RE: Isolating the system for a planned power cut
@transparent 😊 I may have lost you there.. I ...
By Batpred , 1 day ago
-
-
RE: Low COP and unevenly heated rooms with 12kW Samsung AE120MXTPEH / AE260TNWTEH
Where is the noise coming from. If its the pump then p...
By JamesPa , 1 day ago
-
The Mars and Richard Kitchen Show
Just stopping by to say: 1) Mars I'm so sorry that yo...
By Lucia , 2 days ago
-
RE: Electricity price predictions
Without getting too much into politics, given that the ...
By Batpred , 2 days ago