Last seen: Dec 22, 2025
OK. So 1967 for the original build, but when was that cable laid by WPD, when they quoted £4.5k for 3ph?
Ah... so your original supply contract was with WPD, rather than NGED, and presumably before 2021. I fully understand you feeling robbed.A lot has c...
Not necessarily @adamk It's likely/possible that the existing/ new underground cable already has 3ph conductors.NGED have been doing that for severa...
I wish we'd spoken before all that debacle happened! 1: Here's the Standards document which describes the changes to the Service Fuse. It's is...
@adamk You will need to make an LCT application to your DNO (National Grid) in order to have a heat pump installed. It's free, but worthwhile doing...
Yes @jeff and @kilowatts_io you're largely correct It's a Cap and Flaw arrangement based on the revenues accrued by National Grid Group for operatin...
Yes Bob. An LCT Application is for all sites where a heat-pump or EV charger is to be connected to an existing supply. To see an example of where ...
@jeff NESO now operates all GB energy networks, including heat.They also hold the remit for strategic grid planning. The three Transmission Grid co...
There isn't much correlation between the forwards projection of energy pricingand the tariffs which a very few people are using to significantly lower...
That's a good question @bobtskutter Yes, you can install a heat-pump on a DIY basis. The legal requirements you need to fulfil are: Apply to y...
Latest Posts
-
Sadly, no, @agentgeorge. The inverter will handle 5kW t...
By Majordennisbloodnok , 5 hours ago
-
RE: New Fogstar 15.5kWh upright solution
@transparent The readings are 0 for amps, 0 ...
By Batpred , 6 hours ago
-
RE: Say hello and introduce yourself
@velcro welcome to the forums. Please feel free start a...
By Mars , 6 hours ago
-
RE: Speedcomfort radiator fans
I watched the video to see whether they'd potentially b...
By Sheriff Fatman , 6 hours ago
-
RE: Mitsubishi Ecodan R290 10kW performance
@ecoste For what it's worth, this is my equivalent data...
By Sheriff Fatman , 7 hours ago
-
Daikin EDLA11D3V3 DHW Settings
I have a newly installed EDLA11D3V3 which I'm still get...
By Velcro , 7 hours ago
-
RE: Setback savings - fact or fiction?
Will come back to the above points, but for now, I've j...
By cathodeRay , 8 hours ago
-
@jamespa I have found that it comes as a shock when we ...
By Toodles , 9 hours ago
-
RE: My Powerwall 3 Consumes 3-4 kWh/Day in Self-Consumption: Is This Normal?
I suspect a good chunk of the "losses" are power consum...
By Bash , 10 hours ago
-
RE: Need Help Optimising My Rushed ECO4 Install: 12kW Bosch Heat Pump
Hi @mickamills . Welcome to the forum. It sounds like...
By bontwoody , 11 hours ago
-
RE: Midea ASHP – how to set weather compensation
@curlykatie did you get sorted with this?
By MickaMills , 11 hours ago
-
RE: External pipework insulation
@transparent I hope you are not being admonished @trans...
By Toodles , 11 hours ago
-
RE: Octopus Cosy Heat Pump Owners & Discussion Thread
The FT levels off at either the set point OR the minimu...
By AndrewJ , 1 day ago
-
RE: MyVaillant Connect Regular Disconnect
Thanks. Yes, if the time is consistently 11pm every nig...
By buckwem , 1 day ago
-
RE: Who's your electricity provider and what's your tariff?
@transparent Thanks, this helps. Could it be that St...
By Batpred , 2 days ago
-
RE: Clivet ASHPs and weather compensation
Simon did share a lot of very helpful advice. On furthe...
By ambris , 2 days ago
-
-
RE: Advice on internal circulation pump noise
Extend the primary branch and make sure you have more t...
By ASHP-BOBBA , 2 days ago
