Last seen: Dec 27, 2023
@derek-m thank you 🙂
@derek-m That’s the photo - I can use the heat source pump from this controller - however sorry I’m a bit daft and don’t know what DIP or Sw8 etc i...
@derek-m I think I managed to attach a pic of the j1 fault -
@sunandair thank you for the reply - I tried this already a few weeks ago - I watched a you tube video to pair up - i also did a full system reset inc...
@derek-m hi - I have a J1 fault on the main panel (this means it’s not talking to my thermostat and I can’t reset this as I have tried all options) my...
@derek-m I’ve had a similar problem lately - I originally got a J1 issued on my main panel and now my heat source won’t turn off (the fan outside isn’...
@harriup thank you ! I’ll try giving this a go - I work for a heating company so I’ll get one of our senior engineers to try after Christmas and pop b...
Sorry for the delay - yes I mean this but mine has green light on top and when you reset it the orange light to the left flashes (it’s then supposed t...
Latest Posts
-
We are 2 weeks away from our HP install. I'm October ...
By Bash , 35 seconds ago
-
RE: Experience - New Build / Complete New Heating System
Welcome to the forums @vincro and good luck with finali...
By Mars , 1 minute ago
-
I’m glad the cold spell is over!
Just a sigh of relief that the cold spell is over and t...
By Judith , 12 minutes ago
-
RE: Heat pump not reaching flow temperature
@jamespa the compressor does run at max operating frequ...
By DaveC , 14 minutes ago
-
RE: Post-Traumatic Heat Pump Stress Disorder
@johnbroome As I say I think you probably have a fau...
By JamesPa , 25 minutes ago
-
RE: Recommended home battery inverters + regulatory matters - help requested
So far as i can see no because its NOT connected to the...
By JamesPa , 2 hours ago
-
RE: Please help with the settings ecodan
Hi and welcome to the forums.Does your system use a Mit...
By Sheriff Fatman , 2 hours ago
-
RE: New Daikin 11kW Altherma 3M install - is it working as it should?
I forgot to mention: Octopus measured our heat loss at ...
By Toodles , 3 hours ago
-
RE: Considering MLCP (Multi-Layer Composite Pipe) for ASHP
Thanks Mars and thank you for reaching out to so many p...
By iotum , 3 hours ago
-
RE: Air source heat pump roll call – what heat pump brand and model do you have?
Forum Handle: @davec Manufacturer: Peak Energy Mode...
By DaveC , 3 hours ago
-
RE: Rate the quality of your heat pump design and installation
@radwhispererdwhisperereorourkeditor Well, the guy came...
By razz , 3 hours ago
-
RE: Setback savings - fact or fiction?
Given the weather has been relatively stable, the empir...
By Batpred , 4 hours ago
-
RE: GSHP WOES! Midland based engineer recommendations?
@editor That is very kind! Thank you so much.
By johnbroome , 5 hours ago
-
RE: ASHP Energy Consumption: Aira 12kW heat pump
@wally Hi I am not sure how large your house is b...
By TechnoGeek , 6 hours ago
-
RE: Predicted Heat Loss & Needs from MCS calcs vs EPC vs actual
I've been thinking along similar lines to @tim441 from ...
By Sheriff Fatman , 7 hours ago
-
Thanks, @technogeek. Good to hear about the accuracy. ...
By Majordennisbloodnok , 7 hours ago
-
RE: Advice for a novice on Mitsubishi Ecodan 6kW
In my case it was a very specific pattern of behaviour ...
By Sheriff Fatman , 7 hours ago
-
RE: Vaillant aroTherm not heating with many faults
@ashp-bobba Yeah I'll give it a go, will check filter...
By Anon67 , 8 hours ago
-
RE: RDSAP10 effect on existing heat pump EPC rating?
@transparent Perhaps the names at the end of the docume...
By Toodles , 8 hours ago
