Last seen: Jun 3, 2025
This phot of the curve setting when set up in February
Also the heating has never worked in the colder weather, but other issues were found which different engineers thought was the cause but still none ha...
@derek-m Home Size is 450sq/m traditional build with external/internal block walls with cavity and stone faced and some large glazing. The floors are...
@derek-m That's the issue is that it works when the OAT is above say 8deg and achieves the required flow temps to heat the house but once the OAT drop...
Now that we have had a cold snap in the weather I recorded the relevant info as previously mentioned. The system has been good up until Friday where ...
@derek-m Thanks for reply, I will collate the relevant info and come back to you.
@derek-m I have attached the schematic with the relevant info as suggested previously, I am not convinced with my digital thermal reader so need to...
@derek-m Where do i find the speed settings for the pumps?
@derek-m Thanks for the feedback, the buffer tank was recently fitted in place of a low/loss header tank (think that's the correct terminology). I wi...
@derek-m I would say that I am okay technically and learning all the time through this process, Also I have digital laser thermometer that I can use t...
@derek-m Still unknown at this stage due to number of factors but early indication is that its still the same. Since the last post we had to get an e...
@kev-m Thanks for the reply. Picking up on your first observation, what should the flow temp be set at for UFH? On the issue when the outside temp ...
Latest Posts
-
RE: Commencing on an ASHP Installation Process
That outside pipework would concern me. Surely rigid se...
By benson , 3 hours ago
-
As I have reported elsewhere we turned on the cooling o...
By downfield , 6 hours ago
-
RE: Adding battery storage to SolarEdge PV system
Sadly I fear that they may well be right to do so. ...
By JamesPa , 8 hours ago
-
-
@el3b Hi, sorry to hear that, it is advisable to instal...
By ASHP-BOBBA , 1 day ago
-
RE: Difficult positioning of air source heat pump
@rikiarn Out of intrigue, the thread reads as though Ai...
By Sheriff Fatman , 1 day ago
-
RE: Mitsubishi Ecodan Fails to Heat Water despite temperature drop
@m1kegibson If you are able to access the service me...
By HarriUp , 1 day ago
-
RE: When will heat pumps and install prices come down?
... which of course is impossible because the world mov...
By JamesPa , 2 days ago
-
RE: Surface mount or bury primaries for heat pump installation?
What you run the cable through will affect its current ...
By Transparent , 2 days ago
-
My advice is reject unless they will delete the buffer ...
By JamesPa , 2 days ago
-
RE: Battery storage to run Heat Pump.
I would be surprised if the battery chemistry is going ...
By Transparent , 2 days ago
-
RE: Air source heat pump roll call – what heat pump brand and model do you have?
@dowallydrifter OK. I would recommend you read t...
By JamesPa , 3 days ago
-
RE: Solar to power Heat Pump for DHW
Wow, how big is your heat pump that it is pulling 6kW d...
By Old_Scientist , 3 days ago
-
There are DHW tanks with a built in heat pump that take...
By JamesPa , 4 days ago
-
RE: Vaillant AroTherm Plus 7kW
If the thermostat is connected to the call for heat ter...
By JamesPa , 4 days ago
-
RE: Renewables & Heat Pumps in the News
Yes I realise I'm picking this up a week late...... but...
By Transparent , 5 days ago
-
RE: Getting the best out of a heat pump - is Homely a possible answer?
@cathoderay how did you get a script to run for that- d...
By benson , 6 days ago
