Last seen: Apr 9, 2025
You will love this, regards the house config, different improvements have happened at different times, hence the mix-mash, at one point we had 2 gas b...
The house has not been turned upside down, bedrooms are all upstairs. So the way you would start and sorry to keep going on - would be that you set ...
Let me try answer what I know.Yes it's the same pump, and original design and install had the whole system as 1 the only limit was on the control unit...
I am not sure this is an option for me at all, if my heat curve is low the downstairs will be fine but upstairs and kitchen will be cold, if I set it ...
Think I figured something out for once. Adaptive heat curve was on, I believe this was adjusting my heat curve automagically, turned it off see if it...
Noise reduction I have no plans so I assume is off always. Bizarre part I noticed is my heating curve was set to 0.5 - I change it to 0.3 and 0.9 an...
I do not believe it's in quiet mode - what setting is that so I can double check? I believe the volume should be fine, as I have a 150l Volumiser an...
Back -- So between 2am and 6:30am it's trying to reach a target temp of 40-42c, it's obviously trying to get there and cycling around every 20 minutes...
I must admit with cheap rate overnight, I’m starting to abandon a 2c setback, some rooms take too long to recover. Still playing around trying to find...
Thanks, I'm away at the minute so cannot get to my HA flow temp graphs, but I have it it running on a more constant basis, and I get this feeling that...
Yes I am finding that running it long and low is the better outcome also more comfortable throughout. with regards the water pressure what’s the po...
If I take out what the water heating from the gas, then I would say yes the generated kw is about right from previous, I also have an EV and play with...
Latest Posts
-
RE: Commencing on an ASHP Installation Process
I should perhaps have mentioned this in my post, as I'd...
By Sheriff Fatman , 7 hours ago
-
RE: Mitsubishi cycling while on chilled water output
@jamespa you are so much faster than me, happy to see g...
By ASHP-BOBBA , 8 hours ago
-
@jamespa Thanks for the advice - very helpful. I had al...
By abam48 , 18 hours ago
-
RE: Weather compensated secondary circuits with Biomass
Hi @andycoo we do an LK 110 standalone weather compensa...
By Sune , 19 hours ago
-
RE: Adding battery storage to SolarEdge PV system
@chandykris No need to apologise at all! I forgot to ad...
By Toodles , 2 days ago
-
RE: Say hello and introduce yourself
Yes please do Suggesting a loss in the region...
By JamesPa , 2 days ago
-
RE: Surface mount or bury primaries for heat pump installation?
Can we have some links to those you're considering plea...
By Transparent , 2 days ago
-
As I have reported elsewhere we turned on the cooling o...
By downfield , 2 days ago
-
@hughf, I think we’ll organise an RHH session at Instal...
By Mars , 3 days ago
-
@el3b Hi, sorry to hear that, it is advisable to instal...
By ASHP-BOBBA , 3 days ago
-
RE: Difficult positioning of air source heat pump
@rikiarn Out of intrigue, the thread reads as though Ai...
By Sheriff Fatman , 4 days ago
-
RE: Mitsubishi Ecodan Fails to Heat Water despite temperature drop
@m1kegibson If you are able to access the service me...
By HarriUp , 4 days ago
-
RE: When will heat pumps and install prices come down?
... which of course is impossible because the world mov...
By JamesPa , 4 days ago
-
RE: Battery storage to run Heat Pump.
I would be surprised if the battery chemistry is going ...
By Transparent , 5 days ago
