Activity
 
Notifications
Clear all
HughF
@hughf
Member
Noble Member
2918 kWhs
Joined: May 2, 2022
Last seen: May 6, 2024
Topics: 7 / Replies: 472
Reply
RE: ASHP Cut-off Temperatures: What's Your Setting and is a Your Heating Still On?

My system has been running 24/7 on weather compensation from last September until today when I fitted a thermostat. I did think about just changing ...

2 weeks ago
Reply
RE: Is this a bad installation and is there something wrong with my Samsung heat pump?

@editor I was at the Exeter tool fair/electricians show a couple of weeks ago and MCS had a fancy booth there. I was tempted to go and ask them what e...

2 weeks ago
Reply
RE: Is this a bad installation and is there something wrong with my Samsung heat pump?

If they don’t fix it, I’d just do it yourself - the Samsung is a piece of piss to install. Buffer tank in the bin, TRVs in the bin, Samsung cont...

2 weeks ago
Reply
RE: Is this a bad installation and is there something wrong with my Samsung heat pump?

Have you decided what you’re going to do about this install, who you’re going to complain to?

2 weeks ago
Reply
RE: Is this a bad installation and is there something wrong with my Samsung heat pump?

Room stat/call for heat wires are polarity insensitive, it’s just a switch.

2 weeks ago
Reply
RE: Defrost cycle question

A valve in the heat pump causes the direction of the refrigerant to change. The water circuit carries on pumping as usual.

2 weeks ago
Reply
RE: Installing your own ASHP - DIY

I’m in the DIY camp, completed the install last September and it has been running 24/7 since then. Slightly different choice of install (15m up the ...

2 weeks ago
Reply
RE: Is this a bad installation and is there something wrong with my Samsung heat pump?

@david999 On the subject of isolation after the battery, class T fused disconnect (two pole) is what is be using…. Not at all expensive.

3 weeks ago
Reply
RE: Is this a bad installation and is there something wrong with my Samsung heat pump?

Samsungs are so easy to install, you could fix this yourself if you wanted…. How many pumps do you have? (It will either be one or two, it shouldn’t...

3 weeks ago
Reply
RE: New Fogstar 15.5kWh upright solution

Sunsynk not the best in my experience. Poor software, lacking in features…. very poor overload capability.

3 weeks ago
Reply
RE: Removing a Low Loss Header from Samsung Gen6 System

@heacol easily resolved with a jumper wire on the end of the flow sensor cable 🤣 When I was commissioning my Sprsun I could not get the air ...

2 months ago
Reply
RE: Removing a Low Loss Header from Samsung Gen6 System

@ecobaker ah damn…. Swap that out for a UPM GEO then….

2 months ago
Page 1 / 40
Share:

Join Us!

Latest Posts

Heat Pump Humour

Members Online

x  Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
Shield Security