Activity
 
Notifications
Clear all
glpinxit
@glpinxit
Member
Trusted Member
409 kWhs
Joined: Mar 16, 2023
Last seen: May 3, 2024
Topics: 5 / Replies: 20
Reply
RE: Observations on my Ecodan's estimates of energy consumed and delivered

@hestia I haven't touched this setting. As I can't detect a pattern in the Ecodan overestimates of energy consumed and have nothing to use as a basis ...

2 weeks ago
Reply
RE: Credit Card Payment – Section 75 – for heat pump installations

Ours (installed in Summer 2022) included an insurance backed guarantee and a deposit protection scheme. Happily we have needed neither.

1 month ago
Reply
RE: Electricity use for heat pumps - comparing homes and consumption

I have now posted the % comparison between measured energy consumption and the estimates provided by my Ecodan. Upthread I'd said that I would do this...

2 months ago
Reply
RE: Electricity use for heat pumps - comparing homes and consumption

@sunandair rather than keep cluttering up this thread I'm going to start a new thread about my Ecodan's figures for its energy consumption. I'll inclu...

3 months ago
Reply
RE: Electricity use for heat pumps - comparing homes and consumption

@skd Thank you. I've set myself the objective (for now at least) of not making fundamental changes to the design or our ASHP system. Instead I'm seein...

3 months ago
Reply
RE: Electricity use for heat pumps - comparing homes and consumption

@skd the controller is an FTC6 but because of the third party thermostat/timers we don't have access to AutoAdaptation or to run the two heating zones...

3 months ago
Reply
RE: Electricity use for heat pumps - comparing homes and consumption

To stray back in the direction of the question asked by @Rad1o 190sqm 4 bed house, conventionally built in 2004, two occupants. 11.2kW Ecodan re...

3 months ago
Reply
RE: How are Ecodan CoP quotes from MelCloud setups?

I started daily recording the FTC6 heat consumed and delivered figures last February. I paused in the summer (going to weekly) and resumed in October....

4 months ago
Reply
RE: Performance in the current cold snap…

@iancalderbank and @cathoderay recognising that I may be over-simplifying- if the infrastructure (ie pipework and heat-emitters) cannot transmit the h...

4 months ago
Reply
RE: Freeze Stat/Defrost setting….Ecodan in freezing conditions

Our Ecodan was installed 18 months ago and glycol was included in the system. Since then I've been meaning to buy a refractometer so I can check the c...

4 months ago
Reply
RE: Flow temperature up and down like a yo-yo

@greekgoddj yours is like our Ecodan 11.2 looked like a year ago (but less regular). This year I've turned up the two room-stats (upstairs and down) t...

6 months ago
Page 1 / 3
Share:

Join Us!

Latest Posts

Heat Pump Humour

x  Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
Shield Security