Last seen: Dec 21, 2025
@pash44pump I have yet to come across any Clivet or Midea complaints aside from the control panel side of things. There was one post on here a few wee...
@rhh2348 ...maybe this option is what you want? Alternatively the immersion heater may be controlled separately. If direct control is not required t...
@9jwr9 oh ok. There will almost certainly be a way to turn it off? Your installer will likely just be reluctant to advise on it as it will be a req...
I think the key question potentially is why you are trying to hit a target temp of 60, all of the time? Why don't you just set it at 50 which the ashp...
Fair play for giving this a go, and please do report back. I have done exactly the same testing comparisons for Homely versus pure weather comp and ...
Not that I know of. It’s a regular complaint with respect to the midea. Connecting something up to the modbus is the way to go, and then you can als...
There's no setting. The app just doesn't work properly. We had exactly the same on ours- it would completely disconnect and/or this data would vanish....
Yes, I would- based on what you have said with respect to your house being too warm, and furthermore you want your linear relationship between OAT and...
Indeed- front door was open for a relatively sustained period of time, which is where this temp sensor is near to (hallway). On rare occasions when ...
This also hopefully gives you an idea of what you should be able to achieve with no indoor thermostat influence. Our IAT (indoor air temp) stays betwe...
As a starter for ten I'd lower the cold side of your curve. You say design flow temp of 47 at whatever the outside design temp was. Maybe I have assum...
@stevet you have come to the right place. The knowledge on this forum surpasses that of most installers, particularly when it comes to configuring and...
Latest Posts
-
RE: Mitsubishi Ecodan R290 10kW performance
As far as I'm aware from discussions with the installat...
By Sheriff Fatman , 41 minutes ago
-
RE: MyVaillant Connect Regular Disconnect
Sadly, if the gateway is still responding to pings on t...
By Majordennisbloodnok , 2 hours ago
-
RE: Octopus Cosy Heat Pump Owners & Discussion Thread
Bearing in mind that Octopus can apparently monitor our...
By KevH , 4 hours ago
-
RE: Speedcomfort radiator fans
My take on Speedcomfort radiator fans: If anyone w...
By Mars , 5 hours ago
-
RE: Midea ASHP – how to set weather compensation
@pash44pump I have yet to come across any Clivet or Mid...
By benson , 5 hours ago
-
RE: Who's your electricity provider and what's your tariff?
@transparent Thanks, this helps. Could it be that St...
By Batpred , 5 hours ago
-
RE: Clivet ASHPs and weather compensation
Simon did share a lot of very helpful advice. On furthe...
By ambris , 6 hours ago
-
My Powerwall 3 Consumes 3-4 kWh/Day in Self-Consumption: Is This Normal?
I had solar panels & Powerwall 3 installed in Augus...
By Caron , 7 hours ago
-
-
RE: Setback savings - fact or fiction?
I could, but I think we can do better, by plotting hour...
By cathodeRay , 23 hours ago
-
RE: Advice on internal circulation pump noise
Extend the primary branch and make sure you have more t...
By ASHP-BOBBA , 1 day ago
-
RE: External pipework insulation
Oh Dear! that's appalling pipe work, should've been in ...
By dgclimatecontrol , 1 day ago
-
RE: Jokes and fun posts about heat pumps and renewables
By Morgan , 1 day ago
-
RE: Controlling Daikin Altherma via P1P2 and Home Assistant
On the contrary, @toodles, that’s a lot of help. I’d ne...
By Majordennisbloodnok , 1 day ago
-
Parsnip, Bacon & Coconut Milk Soup
First let me say, I am only a cook because I am human a...
By Toodles , 2 days ago
-
RE: Electricity price predictions
Ben Watts posted on LinkedIn that he had updated this w...
By Judith , 2 days ago
-
RE: The good, the bad and the not that great – my heat pump installation
Small update, Emailed and Spoke to Midea UK and they ...
By Burtis , 2 days ago
-
RE: Solis S6-EH1P8K-L-PLUS – Why I Chose It and What I’ve Learned So Far
@bash Octopus does charge for the admin. The process al...
By Batpred , 2 days ago
