Thinking about an air source heat pump in Aberdeenshire
Hi,
We had a Vaillant ASHP 12kw fitted last October. We have a big old drafty cottage on the Yorkshire coast and had no choice but to install before we could do any other work. The majority of the house cant be insulated as its chalk,cobble, mud etc with no cavity only in a later extension. We have the whole pipework replaced and triple rads fitted. It worked lovely in the winter reaching 20degrees which was sufficient however it was costing about £300pm! Once we realised we lowered the heat and turned some rads right down. It also cut out in -2 temp, but they claim thats because it needs a bigger cable (we had problems with the fitters you can see on another thread).
I now take the meter reading everyday to check and we use about 5 units a day at the moment in total (not just hot water), we have had new windows and doors fitted and kingspan on many of the internal walls. More to do, but expecting it to perform much better this winter.
Look us up on facebook 'bramley manor cottage' and you'll see if the size is comparable to yours.
We need solar panels but neighbours are whinging about everything so far and we are running out of money so not sure when that will happen but id imagine it would then be really economical.
Good Luck
@stevebrockie3, If your installers are MCS certified, they have to do a room, by room calculation that takes your current build, insulation levels, ventilation and room temperatures (21 in the living areas and 18 in the bedrooms) in to account. Ask them for this, they have to give it to you with your quotation and with this there should be a radiator schedule for every room. In addition to this, ask the installer for manufacturer's evidence that the chosen heat pump will supply the required heat at the design temperature or duty point (usually between -1 and -5 depending on latitude and altitude). They should also be able to supply you with performance and running cost estimates, do not be afraid to interrogate these thoroughly, good installers will welcome it. If the installer struggles with this, get another installer.
If your installer is not MCS certified, get another one that is, as you will not be able to claim the RHI grant.
Director at Heacol | Expert Heat Pump Consultant | Book a one-to-one consultation for pre- and post-installation advice, troubleshooting and system optimisation.
@stevebrockie3, did you end up committing to an air source heat pump?
Pre-order: The Ultimate Guide to Heat Pumps
Subscribe and follow our Homeowners’ Q&A heat pump podcast
@editor hi Mars, no we didn’t in the end. We’ve decided to grin and bear the extortionate LPG costs for another winter then will look into Biomass in the spring. Meanwhile we’re replacing all the windows and beefing up the loft/eaves insulation and will put in composite front/back doors as the old timber doors have to be a major contributing factor to the heat loss.
- 26 Forums
- 2,123 Topics
- 46.7 K Posts
- 36 Online
- 4,531 Members
Podcast Picks
Latest Posts
-
RE: How do I choose a single room MVHR to prevent losing heat in my bathroom ?
An update on the Heatsava. It is the most difficult thi...
By heat-pump-newbie , 1 hour ago
-
RE: Octopus Cosy & Octopus EV + bidirectional smart tariff, together. What, eh?
I've certainly seen that on their Ts & Cs page but ...
By Majordennisbloodnok , 20 hours ago
-
RE: Planning Permission May 2025
Where does it state this please? Im genuinely interest...
By JamesPa , 23 hours ago
-
RE: ASHP heat output monitoring
@carlo - not much better, is it. It looks more like a u...
By cathodeRay , 1 day ago
-
RE: Renewables & Heat Pumps in the News
this document extensively describes (in a non-blame, ne...
By Judith , 1 day ago
-
RE: Ecodan - Legionella Operation Time and Target Temperature
Once the white plastic cap is removed, my immersion loo...
By Old_Scientist , 2 days ago
-
RE: Replacing Refrigerant on Mitsubishi Heat Pump
@dgclimatecontrol I don't know, but they were not happy...
By DavidAlgarve , 2 days ago
-
RE: Why do we need pressurised systems?
A good question @toodles. My old open thermal store and...
By AllyFish , 2 days ago
-
RE: 300 Liter Tank - Do I have to heat it all?
Cross references for @martingale Background discussi...
By Transparent , 3 days ago
-
@ecobaker May I ask a question of you please. I too hav...
By Papahuhu , 3 days ago
-
RE: Share Your Experiences with Heat Pump Manufacturer Support
@terry1812 Oh Good! Pleased to help if I can! Regards, ...
By Toodles , 3 days ago
-
It's unclear to me how the Smart Control project work b...
By Transparent , 3 days ago
-
RE: Have Consumers Been Lied to About the Efficiency of Heat Pumps Made in China?
@pavel, this isn't about discrediting Chinese products....
By Mars , 3 days ago
-
RE: Solar Power Output – Let’s Compare Generation Figures
We had an excellent four months (11/3 to 15/7) generati...
By JulianC , 6 days ago
-
RE: Is this just haze or something more?
I think the present somewhat cooler hazy days show the ...
By Judith , 6 days ago
-
RE: My misgivings about installing ASHP and solar panels via the ECO4 scheme...
All noted and accepted and as I say I am sorry that you...
By JamesPa , 6 days ago
-
I think it is very much me that is sitting outside the ...
By Grantmethestrength , 6 days ago
-
RE: Who's your electricity provider and what's your tariff?
Aggregators have been recognised for many years, and it...
By Transparent , 7 days ago