Activity
 
Notifications
Clear all
Rich
@rich
Member
Trusted Member
152 kWhs
Joined: Oct 13, 2022
Last seen: Feb 1, 2024
Topics: 2 / Replies: 16
Reply
RE: Ecodan help with efficiency setup and design - removing manifold mixers, LLH and pumps

Thanks yeah I am using the FTC controller as the stat so I am just trailing Advanced Auto Adaption however I have noticed this raises the LWT signific...

10 months ago
Reply
RE: Ecodan ASHP - How to optimise my set up?

Thanks for all the replies @sliderule I have tried AAA as I have FTC6 however this ramps the flow temperature up a lot and I thought this was the most...

10 months ago
Reply
RE: Ecodan ASHP - How to optimise my set up?

My settings are 37c @ -5c to 26 @ 15c I would like this lower as the house is 21c feeling a bit to warm sometimes however I am already getting a lo...

10 months ago
Reply
RE: Ecodan ASHP - How to optimise my set up?

for some reason my screenshot wasn't included this is the cycling OAT 6c at 11-12 today weather comp trying to keep to 31c

10 months ago
Reply
RE: Ecodan ASHP - How to optimise my set up?

Hi @jaket we have similar systems 100% eclectic house, Ecodan 8.5kW - PUZ-WM85VAA, 210l pre plumbed cylinder, full house UFH total floor about ...

10 months ago
Reply
RE: Ecodan help with efficiency setup and design - removing manifold mixers, LLH and pumps

morning all, The system has now been running 24/7 since Friday in weather compensation mode and the house is sat at 21c downstairs 20c upstairs. ...

10 months ago
Reply
RE: Ecodan help with efficiency setup and design

Time for an update I had some time the last few days and with the warmer weather decided its now or never. I'm no plumber but for a first go I am...

11 months ago
Reply
RE: Ecodan help with efficiency setup and design

Thanks for the reply I haven't yet altered the pipework as decided the coldest part of the year is not the best time if anything was to go wrong, I ...

11 months ago
Reply
RE: Ecodan help with efficiency setup and design

thank you that's very good to hear, I will hopefully start the mods at the end of the week all going well. alongside I plan to rewire so the main FT...

11 months ago
Reply
RE: Ecodan help with efficiency setup and design

Thanks for all the advice, I have contacted the original installer and asked if they can send over any information they might still have. You are c...

11 months ago
Reply
RE: Ecodan help with efficiency setup and design

Yeah I hope some calculations were done I think the company just sent all the plans to Mitsubishi and they suggested this if I’m completely honest. Th...

11 months ago
Reply
RE: Ecodan help with efficiency setup and design

Thanks I did not receive a pack so will contact again, I don’t have very high hopes as the company who did all the plumbing had a MCS certified person...

11 months ago
Page 1 / 2
Share:

Join Us!

Latest Posts

x  Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
Shield Security