Daikin Altherma 3 8kW not working as needed
Hi @toodles sounds very much like our situation with our Daikin - we have three people in the house, two of us working from home. Our daily 'background' (non-heating, non-DHW) averages 12 kWh in the winter - from three years of data I've determined that breaks down to 5 kWh for normal variable activity, 4 kWh for non-ASHP background (e.g., average consumption when we are holiday), and 3 kWh for the ASHP 'background' - what it uses just being switched on and doing nothing useful; on top of that our DHW (two cycles per day, one 5.30am, one 1pm) averages 5 kWh. Its sounds as you say like we are in the same ballpark - albeit our absolute heating demand is higher due to sq m - we are (12 + 5 + 28.5) to your (10 + 4 + 12) for (background + DHW + heating), if I'm reading correctly. Do you use setback or is the space heating 'on' 24x7?
I think I saw an article by Protons for Breakfast where he looked at a histogram of his kWh consumption - I followed his approach and to your point it was comforting to see that yes those cold days of high consumption really are outliers - this is how my data looked last winter (total grid consumption for winter heating season 22-23):
If I subtract 17kWh from the data I more or less get my space heating kWh consumption - i.e., same distribution.
We also have 6.1 kWp of solar (averaging around 11 kWh p/d in this heating season, of which on average we use 9 kWh p/d), no batteries, UFH + rads, 30cm loft insulation, double glazing for comparison.
@marzipan71 Hello Marzipan, I did experiment with setback but it didn’t appear to reduce consumption according to the readings. I suppose any resting time had to be compensated for when returning to ‘normal’ settings again. Both being retired, we are here most of the time so 22.5 degrees C. 24/7 suits us well. Homely is very good at holding the temperature constant for most of the time - I have found that there is a rise of 0.6 to 0.75 in the early evening and that may have been Homely making best use of OE’s Cosy tariff but I have just swapped back to Agile so will see. More later no doubt! Regards, Toodles.
Toodles, he heats his home with cold draughts and cooks his food with magnets.
- 22 Forums
- 2,084 Topics
- 46 K Posts
- 49 Online
- 3,377 Members
Trusted Installers
Struggling to find a reliable heat pump installer? A poor installation can lead to inefficiencies and high running costs. We now connect homeowners with top-rated installers who deliver quality work and excellent service.
✅ Verified, trusted & experienced installers
✅ Nationwide coverage expanding
✅ Special offers available
Latest Posts
-
RE: Surface mount or bury primaries?
@editor My side access already contains services, so it...
By tomasmcguinness , 16 minutes ago
-
RE: Getting the best out of a heat pump - is Homely a possible answer?
It took me more than a few goes as well, plus some help...
By cathodeRay , 14 hours ago
-
RE: Renewable Heating Hub Homeowners' Q&A Podcast
@ashp-bobba thank you, and equally so, thank you for ta...
By Mars , 1 day ago
-
@judith good to know… I’ll continue to feed Wattson, an...
By Mars , 1 day ago
-
RE: Vaillant AroTherm Plus 7kW
@jamespa I have a hydronic baseboard heater in the kitc...
By Scalextrix , 2 days ago
-
RE: My misgivings about installing ASHP and solar panels via the ECO4 scheme...
@editor great article re accreditation. I note ISO/IEC ...
By Bart , 2 days ago
-
RE: Renewables & Heat Pumps in the News
Here’s a little more technical detail/p>
By Judith , 3 days ago
-
RE: Who's your electricity provider and what's your tariff?
I don't (yet), but my PW3 is due to be installed shortl...
By Old_Scientist , 3 days ago
-
RE: MCS and NAPIT complaints process
@chrislay, is your heat pump complaint still unresolved...
By Mars , 3 days ago
-
RE: ASHP Install from hell - help please
@saf1973 I’ve been going through old cases on the forum...
By Mars , 3 days ago
-
RE: RDSAP10 effect on existing heat pump EPC rating?
@aaron There's the rub, the database does not list my ...
By AF1 , 4 days ago
-
RE: Commencing on an ASHP Installation Process
Yes, it's "doable" if everything goes to plan, they arr...
By Old_Scientist , 5 days ago
-
RE: How not to install a heat pump
You are right. Thinking on this has evolved over the p...
By JamesPa , 6 days ago
-
RE: DHW SET UP with Samsung gen 5
Thats good news indeed, you are very likely almost ther...
By JamesPa , 6 days ago
-
RE: Plate heat exchanger considerations
As far as I can tell my vented system would have a peak...
By Scalextrix , 6 days ago
-
RE: Air Changes per Hour - ACH and the MCS requirement
There have been a few discussions dotted around (e.g. I...
By Declan90 , 6 days ago