Outdoor WiFi Antenna
We need to boost our WiFi outdoors to cover a growing number of outdoor WiFi connected products. Any suggestions or recommendations?
Buy Bodge Buster – Homeowner Air Source Heat Pump Installation Guide: https://amzn.to/3NVndlU
From Zero to Heat Pump Hero: https://amzn.to/4bWkPFb
Subscribe and follow our Homeowners’ Q&A heat pump podcast
Do these outdoor products plug into an outdoor power socket? Or do you have an outdoor power socket near where they're located?
105 m2 bungalow in South East England
Mitsubishi Ecodan 8.5 kW air source heat pump
18 x 360W solar panels
1 x 6 kW GroWatt battery and SPH5000 inverter
1 x Myenergi Zappi
1 x VW ID3
Raised beds for home-grown veg and chickens for eggs
"Semper in excretia; sumus solum profundum variat"
@majordennisbloodnok, that’s the dilemma. Some are POE (power over ethernet), so it entails running a cable. I have access to power outside in a number of places, but getting the internet to it is a challenge.
The silver cavity insulation wreaks havoc with our WiFi outside.
Buy Bodge Buster – Homeowner Air Source Heat Pump Installation Guide: https://amzn.to/3NVndlU
From Zero to Heat Pump Hero: https://amzn.to/4bWkPFb
Subscribe and follow our Homeowners’ Q&A heat pump podcast
In that case, powerline adapters may be a simple solution. Some will just provide an RJ45 ethernet socket, some will just act as wifi range extenders whilst some will do both.
The basic premise is simple; you plug two of them in, one close to your router. They will use your electrical cabling like a network cable and so communicate with each other.
It does assume your home electrical cabling is reasonably well done and isn’t so great with 3 phase (or at least across phases) but for most of us it’ll work fine.
105 m2 bungalow in South East England
Mitsubishi Ecodan 8.5 kW air source heat pump
18 x 360W solar panels
1 x 6 kW GroWatt battery and SPH5000 inverter
1 x Myenergi Zappi
1 x VW ID3
Raised beds for home-grown veg and chickens for eggs
"Semper in excretia; sumus solum profundum variat"
@majordennisbloodnok, I've got the AV600 and it doesn't connect to our outdoor buildings – it has to be on the same electricity "loop" and for some reason it doesn't work in our studio or garage.
Buy Bodge Buster – Homeowner Air Source Heat Pump Installation Guide: https://amzn.to/3NVndlU
From Zero to Heat Pump Hero: https://amzn.to/4bWkPFb
Subscribe and follow our Homeowners’ Q&A heat pump podcast
Posted by: @editorWe need to boost our WiFi outdoors to cover a growing number of outdoor WiFi connected products. Any suggestions or recommendations?
Would highly recommend Ubiquiti Unifi Access points & Ubiquiti Airmax Nanobeams to get the data connection to the access point(s). Getting power to PoE devices isn't too much of a problem if you've got sockets nearby, you can just use a PoE injector.
@Colin, I have looked at Ubiquiti – it looks like really good quality. Good point about the PoE injectors. It's an easy workaround.
Buy Bodge Buster – Homeowner Air Source Heat Pump Installation Guide: https://amzn.to/3NVndlU
From Zero to Heat Pump Hero: https://amzn.to/4bWkPFb
Subscribe and follow our Homeowners’ Q&A heat pump podcast
@editor Agreed, good quality gear. I've been running three of their access points for the past couple of years without missing a beat. One of their Long Range access points e.g. the AC-LR or U6-LR might be enough to do the job you need. Some of their Nanobeam gear can go up to 30km.
Have you looked at a TP-link N300 Wireless Outdoor Access point, 200m range for multiple connections and reasonably priced.
@editor, it's pretty clear now that there are details to your situation that will significantly influence any advice given on network kit. Is there any chance within the bounds of sensible privacy that you could give any more specifics?
There are a few questions in particular that spring to mind immediately:
- Could you give a bit of a fuller idea of the layout and relative distances involved? You mentioned two outbuildings (a studio and a garage) that don't have any network equipment at the moment, but presumably both have power. How far away from your house and each other are they?
- Are all the external devices you want to connect clustered in roughly one place or spread far and wide? And how far from the house and/or outbuildings is that?
- Do you have any external power that isn't attached to the outbuildings or house? And is all external power on the same circuit?
- Is there clear line of sight between the various locations involved? House <--> outbuildings, outbuildings <--> devices, devices <--> house etc.? If not, what obstacles are in the way?
- How much data do you expect to be servicing? I'm guessing your internet-enabled external devices won't consume much, but if you get network to the studio, for instance, are you then likely to want to start working from there yourselves?
As always, there are plenty of potential solutions to your immediate problem - some better than others - and several limitations that aren't immediately obvious but a "right" answer will need a bit more info unless you're just happy with us throwing generic suggestions at you of what's good kit.
105 m2 bungalow in South East England
Mitsubishi Ecodan 8.5 kW air source heat pump
18 x 360W solar panels
1 x 6 kW GroWatt battery and SPH5000 inverter
1 x Myenergi Zappi
1 x VW ID3
Raised beds for home-grown veg and chickens for eggs
"Semper in excretia; sumus solum profundum variat"
- 26 Forums
- 2,102 Topics
- 46.2 K Posts
- 84 Online
- 3,388 Members
Join Us!
Latest Posts
-
RE: Compressor attempts start but fails - Nibe Fighter 2005 8kW
@skyefarmer great you located the source of the issue a...
By Mars , 4 hours ago
-
RE: Location of hot water isolation valve on cylinder
@rossowheels if you isolate the water supply in it will...
By ASHP-BOBBA , 13 hours ago
-
RE: Ecodan consuming 100kwh per day in new build!!!
From what you say about the radiators upstairs it does ...
By JamesPa , 18 hours ago
-
The Importance of Radiator Balancing for Efficient Heating: Introducing the Flow Regulating Valve
It’s fascinating to watch how low-temperature heating i...
By Mars , 21 hours ago
-
@heacol, if you're around, can you please provide some ...
By Mars , 24 hours ago
-
RE: Servicing Hitachi HP in rural Somerset
I'd give GreenGenUK a call or email them: sales@greenge...
By Mars , 1 day ago
-
RE: Heating coming on when not required
I played with a max heating temp but there is a world o...
By JamesPa , 2 days ago
-
RE: Pressure drop Primary circuit
I've always regarded topping up heating systems as my j...
By JamesPa , 2 days ago
-
RE: Heat pump solutions and/or installer recommendations for France
I’d travel to France for work if you were struggling wi...
By Damon Blakemore , 2 days ago
-
RE: 5 Star Service from Havenwise
That's always a danger with any new good idea, @morgan....
By Majordennisbloodnok , 2 days ago
-
Have your say in the Renewable Heating Hub Awards
It’s time to celebrate the best (and call out the worst...
By Mars , 3 days ago
-
-
RE: Mitsubishi cycling while on chilled water output
@iaack yes there's no denying that cold air sinks! I s...
By downfield , 3 days ago
-
RE: Weather compensated secondary circuits with Biomass
@andycoo that flooring sounds ideal. Extra volume is ...
By Sune , 3 days ago
-
If you are thinking of heating on the immersion conside...
By JamesPa , 4 days ago
-
RE: Surface mount or bury primaries for heat pump installation?
@tomasmcguinness, I think your best bet would be using ...
By Aventus Eco , 5 days ago