Last seen: May 15, 2025
Yes we have about 300m² on two manifolds, 16 loops. Another manifold is for upstairs rads
Sorry I think you lost the point. The main question was about the CH turning off when DHW was being called for. So having two HP, that person can h...
Some where, someone said they had two HP. with this setup and some changes to the pipes, you could have one HP deal with DHW and CH and the other one ...
I enjoyed reading this response, it so follows our house, but we have different results. Our house is 538m² and built to Passive standards and w...
I just looking into those myself. From what I gather you just put a wire between the two contacts to turn it on. You could use a Grant EP001 (edit sho...
Thank you for that, on those HP that have this facility then setback will work. The Grant doesn't have this, but it may be included in the new contr...
@grantmethestrength thank you for this information.
Why have you put it in here? If its used all the time then fine, that's where it should be. But its the coldest room then the rest of the house will...
You have to take into account what the actual house temp is. If at 16.00 your house is at set temp, then any setback by 1° will turn off the HP. Th...
It all depends on your house and how long it take to lose heat. If you can turn your HP at 16.00 and it only loses say 1/2 ° by 19.00 hrs then that ...
Add me to that list
The system should not be seeing the 23C, in fact it does not see / use any internal temps any more, it is just showing the current temp. The reading o...
Latest Posts
-
RE: Who's your electricity provider and what's your tariff?
@old_scientist I found the switching between tariff jus...
By Toodles , 4 hours ago
-
RE: Plug and play solar. Thoughts?
Have a read of my previous posts on so-called Balcony S...
By Lucia , 7 hours ago
-
@editor @bart Hi, I can see a few problems with your in...
By Brendon Uys , 10 hours ago
-
RE: Ecodan consuming 100kwh per day in new build!!!
Well at least that solves the mystery of where the exce...
By JamesPa , 12 hours ago
-
RE: Compressor attempts start but fails - Nibe Fighter 2005 8kW
"To tell you the truth, I don't know if HAL is homicida...
By Scalextrix , 12 hours ago
-
RE: Location of hot water isolation valve on cylinder
@rossowheels if you isolate the water supply in it will...
By ASHP-BOBBA , 1 day ago
-
The Importance of Radiator Balancing for Efficient Heating: Introducing the Flow Regulating Valve
It’s fascinating to watch how low-temperature heating i...
By Mars , 2 days ago
-
RE: Servicing Hitachi HP in rural Somerset
I'd give GreenGenUK a call or email them: sales@greenge...
By Mars , 2 days ago
-
RE: Heating coming on when not required
I played with a max heating temp but there is a world o...
By JamesPa , 2 days ago
-
RE: Pressure drop Primary circuit
I've always regarded topping up heating systems as my j...
By JamesPa , 2 days ago
-
RE: Heat pump solutions and/or installer recommendations for France
I’d travel to France for work if you were struggling wi...
By Damon Blakemore , 2 days ago
-
RE: 5 Star Service from Havenwise
That's always a danger with any new good idea, @morgan....
By Majordennisbloodnok , 3 days ago
-
Have your say in the Renewable Heating Hub Awards
It’s time to celebrate the best (and call out the worst...
By Mars , 3 days ago
-
-
RE: Mitsubishi cycling while on chilled water output
@iaack yes there's no denying that cold air sinks! I s...
By downfield , 4 days ago
-
RE: Weather compensated secondary circuits with Biomass
@andycoo that flooring sounds ideal. Extra volume is ...
By Sune , 4 days ago
