Notifications

Clear all

ASHP in Hampshire

batalto · 2021-04-22T13:28:11Z

Hi all, Just wanted to talk you through our upcoming ASHP installation. We live on the south coast, just outside of Portsmouth. The house is a detached home of around 260m2 in footprint. The bottom floor was an extended bungalow and we added a second floor. The first floor is standard construction, brick cavity that's filled and double glazed. The upper floor is made of Structurally Insulated Panels (SIPs) with triple glazing. We had to use SIPs because they are lightweight and so wouldn't affect the shallow bungalow foundations. As an upside SIPS are also extremely efficient in retaining heat and have a very low U value, 0.18. The loft has 200mm of insulation in the middle beneath the floor and 400mm of insulation for everywhere else. We have 8.4kW of solar PV on the roof and 7kWh of battery storage (Pylontech batteries). We also have a Solic solar PV heat controller, which will dump excess solar power into the tank before we export. We've just had our EPC done and we scored very highly A (93) that also provided a heat demand of 34w/m2 which tallies with our ASHP assessment of 36w/m2. The ASHP is a 12kw Midea with a stated SCOP of 3.36 supplied and installed by J A Rees, sourced from Freedom Heat Pumps - total cost just under £10k. We will be replacing our current 32kW gas system boiler and hot water cylinder and using the green homes grant for £5k of the cost and I will paying the other £5k. We qualify for the highest RHI so would expect to get roughly £7200 back over the next 7 years. The boiler will be retained as a backup heating system and isolated from the ASHP system. We have been told this is fine with the RHI as its a backup and not hybrid. The heating is currently set to 45 degrees and we have had no problems. Our main living area has a large bifold door system and west facing. This means we have significant heat loss in the winter and for 2 months its very cold and this makes the room chilly, but not cold. All the other months the solar gain is significant, heating the room and the rest of the house. With the conventional boiler the room is chilly, so I am expecting issues in January heating up the room. We might need to come up with a plan for this room, possibly some thick curtains. The install will be next week and should be very straightforward. The ASHP will go on the drive next to the current power intake. The pipework will go straight through the wall into the current boiler room and tap into the current pipework. The tank will need replacement for one with a larger coil, but more or less everything else will remain the same. The aim is 2 days. Currently our gas is 2.5p and electricity is 14p and the current boiler is 58% efficient (according to the boiler) - this leads to a bill of around £1250 for both gas and electricity for the year. With the ASHP, boiler efficiency and assuming a worse SCOP of 2.7 on the current tariff we expect the bill to fall to just under £1,000 (34,000kw of gas to 7,000kw of electricity). This cost includes a standing charge for gas even though we wont be using it. My plan after we have got used to the ASHP is to upgrade the batteries and add 7kw extra, then move to a new tariff. Agile GO is very interesting as I could fill my batteries at night and expend them during the day. The batteries would store 11.4kw (14kW @ 80% Depth of Discharge). I have estimated this would further drop my bills down to £780

Page 4 / 21 Prev Next

Air Source Heat Pumps (ASHPs)

Last Post by batalto 2 years ago

243 Posts

14 Users

128 Reactions

46.4 K Views

RSS

batalto

(@batalto)

Famed Member Member

Joined: 4 years ago

Posts: 1091

Topic starter 08/07/2021 3:19 pm

A few pictures of where we are at the moment - Need to tidy up those battery wires and ethernets (they are way too long)

12kW Midea ASHP - 8.4kw solar - 29kWh batteries
262m2 house in Hampshire
Current weather compensation: 47@-2 and 31@17
My current performance can be found - HERE
Heat pump calculator spreadsheet - HERE

👍

ReplyQuote

JulianC

(@julianc)

Noble Member Member

Joined: 4 years ago

Posts: 322

09/07/2021 6:35 am

Very tidy Midea installation

Daikin Altherma 3H HT 12kWh ASHP with Mixergy h/w cylinder; 4kW solar PV with Solic 200 electric diverter; Honda e and new Hyundai Ioniq 5 N electric vehicles with Myenergi Zappi mk1 charger

ReplyQuote

Mars

(@editor)

Illustrious Member Admin

Joined: 5 years ago

Posts: 3384

12/07/2021 10:26 am

@batalto, looking good.

Pre-order: The Ultimate Guide to Heat Pumps

Subscribe and follow our Homeowners’ Q&A heat pump podcast

ReplyQuote

batalto

(@batalto)

Famed Member Member

Joined: 4 years ago

Posts: 1091

Topic starter 14/07/2021 9:40 am

New tank is in the loft - it fits!

ReplyQuote

Mars

(@editor)

Illustrious Member Admin

Joined: 5 years ago

Posts: 3384

14/07/2021 9:49 am

@batalto, excellent. Do you have any photos?

Pre-order: The Ultimate Guide to Heat Pumps

Subscribe and follow our Homeowners’ Q&A heat pump podcast

ReplyQuote

batalto

(@batalto)

Famed Member Member

Joined: 4 years ago

Posts: 1091

Topic starter 23/07/2021 2:18 pm

Guys came back today to finish off the lagging and tidy up a few areas. Changed out the expansion tank from 18l to 25l. Not really a lot else to see except the services cupboard with all the meters and what not

ReplyQuote

batalto

(@batalto)

Famed Member Member

Joined: 4 years ago

Posts: 1091

Topic starter 23/07/2021 2:51 pm

Boiler cupboard (boiler doesn't work anymore!) - quite messy with old and new pipework. Anything unlagged is old (I assume?!)

ReplyQuote

JulianC

(@julianc)

Noble Member Member

Joined: 4 years ago

Posts: 322

23/07/2021 7:27 pm

Looks good. Why did you keep the boiler?

Daikin Altherma 3H HT 12kWh ASHP with Mixergy h/w cylinder; 4kW solar PV with Solic 200 electric diverter; Honda e and new Hyundai Ioniq 5 N electric vehicles with Myenergi Zappi mk1 charger

ReplyQuote

batalto

(@batalto)

Famed Member Member

Joined: 4 years ago

Posts: 1091

Topic starter 23/07/2021 9:24 pm

Just left it for the time being. I'll probably get rid next year after we've had the winter. It's all disconnected and just a lump on the wall for the moment

👍

ReplyQuote

batalto

(@batalto)

Famed Member Member

Joined: 4 years ago

Posts: 1091

Topic starter 24/07/2021 4:10 pm

Solic now replaced - all working and diverting now. A bit of extra free energy for the tank

ReplyQuote

batalto

(@batalto)

Famed Member Member

Joined: 4 years ago

Posts: 1091

Topic starter 28/07/2021 10:57 am

Next step - RHI application has been placed. Awaiting the process

ReplyQuote

Morgan

(@morgan)

Noble Member Member

Joined: 4 years ago

Posts: 619

28/07/2021 1:51 pm

Still awaiting contact by JL Phillips to arrange to carry out the full technical survey having accepted their quote.

Retrofitted 11.2kw Mitsubishi Ecodan to new radiators commissioned November 2021.
14 x 500w Monocrystalline solar panels.

2 ESS Smile G3 10.1 batteries.
ESS Smile G3 5kw inverter.

ReplyQuote

Page 4 / 21 Prev Next

26 Forums
2,129 Topics
46.8 K Posts
31 Online
5,654 Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed

RE: Heat Pump Servicing & Maintenance – Good Value or Rip-Off?

For reference, our installer has just contacted us afte...

By Old_Scientist , 2 hours ago
RE: How much am I ‘saving’?

@toodles Of course. I've also used Tim and Kat's Gree...

By Old_Scientist , 2 hours ago
RE: Who's your electricity provider and what's your tariff?

Yes, I noticed that change too. The software really doe...

By Old_Scientist , 2 hours ago
RE: Octopus Cosy & Octopus EV + bidirectional smart tariff, together. What, eh?

@old_scientist me too. Just installed my new heat pump ...

By Eliuccio , 19 hours ago
RE: Is your heat pump insured?

Yup just spoke to Privilege to inform them of my impend...

By Scalextrix , 20 hours ago
RE: Forum updates, announcements & issues

Just to keep everyone in the loop, as the site continue...

By Mars , 1 day ago
RE: Fast DHW setting on Midea (Clivet) heat pump

@simon-w, is this something you could potentially assis...

By Mars , 2 days ago
RE: Share Your Experiences with Heat Pump Manufacturer Support

Fwiw I called my installer out for the first time a few...

By JamesPa , 2 days ago
RE: New Vaillant aroTherm Plus in black - When will it come to the UK?

@sandy, I'll send Vaillant an email tomorrow and see if...

By Mars , 2 days ago
RE: Long term efficiency degradation

@jamespa yes as I thought thanks. We have a reaso...

By Scalextrix , 2 days ago
RE: Who has a V2G EV installation

I agree, but a word of caution. V2X is also sometimes u...

By Majordennisbloodnok , 3 days ago
RE: Sunamp Thermino Heat Battery

@jamespa A few days after the installation had been com...

By Toodles , 3 days ago
RE: Planning Permission May 2025

Fair enough. I have read the legislation and MCS020a ...

By JamesPa , 5 days ago
RE: How do I choose a single room MVHR to prevent losing heat in my bathroom ?

An update on the Heatsava. It is the most difficult thi...

By heat-pump-newbie , 5 days ago
RE: ASHP heat output monitoring

@carlo - not much better, is it. It looks more like a u...

By cathodeRay , 6 days ago
RE: Renewables & Heat Pumps in the News

this document extensively describes (in a non-blame, ne...

By Judith , 6 days ago
RE: Ecodan - Legionella Operation Time and Target Temperature

Once the white plastic cap is removed, my immersion loo...

By Old_Scientist , 1 week ago
RE: Replacing Refrigerant on Mitsubishi Heat Pump

@dgclimatecontrol I don't know, but they were not happy...

By DavidAlgarve , 1 week ago
RE: Why do we need pressurised systems?

A good question @toodles. My old open thermal store and...

By AllyFish , 1 week ago
RE: 300 Liter Tank - Do I have to heat it all?

Cross references for @martingale Background discussi...

By Transparent , 1 week ago

Forums

ASHP in Hampshire

Join Us!

Podcast Picks

Latest Posts

Members Online