Forums

Forums
Renewable Heating
Air Source Heat Pum...
Air in the heating ...
 
Notifications
Clear all

Air in the heating system

 
Air Source Heat Pumps (ASHPs)
Last Post by robl 3 years ago
3 Posts
3 Users
1 Reactions
1,737 Views
RSS
 Mike Patrick
(@mike-patrick)
Honorable Member Member
Joined: 4 years ago
Posts: 172
Topic starter 08/12/2022 10:05 pm  

Our underfloor (ASHP powered) system has air in it. I can hear water trickling through the pipework at night and every day canbleed air out of the heated towel rails.

I know this makes it less efficient and have an engineer visiting next week, hopefully to rectify it. He has already been once and identified that the pressure gauge on the heating expansion vessel isn't working so always shows zero pressure instead of what I'm told should be about 1 to 2 bar.

With the current very cold weather our electricity consumption has of course gone through the roof and I'm hoping to see some improvement from fixing this.

But how does the air get into the system? How do you eliminate it? There is no sign of fluid leaking out but the plumber thinks it should be topped up via the fill tube (which the installers helpfully put downstairs while the pressure tank and other pipework are upstairs!).

 

Grant Aerona HPID10 10kWh ASHP


   
Quote
 Cider
(@cider)
New Member Member
Joined: 3 years ago
Posts: 1
09/12/2022 9:05 am  

Few ways. Easiest is to isolate return manifold, close all zones (loops) but one and install hose to return drain point and open. Then open filling loop unit air clear. Repeat for each loop. 
seemingly very few installers know yet alone do this 


   
👍
1
ReplyQuote
 robl
(@robl)
Honorable Member Member
Joined: 3 years ago
Posts: 203
09/12/2022 2:13 pm  

These guys have "deaerators" that can remove microbubbles that are left flowing around a system, might improve matters.  They also sell exotic "vacuum degassers" I think those need electric mind, to directly remove dissolved gasses. 

Never used any of them myself, we have conventional rads with bleed valves all over the place- every time I have ever had the system emptied and refilled it has taken weeks to settle down and stop gurgling.  When I refill it I wish we had a clever pump that jerked on/off as some now do to help clear air locks.  It's only done every 5 years/never, so no worries.  I've trawled around the website looking for pressure versus flow on them, they just say "low pressure drop".

 

https://www.spirotech.co.uk/


   
ReplyQuote



Forum Jump:
  Previous Topic
Next Topic  



Share:

Join Us!

RHH Awards

👉 Vote for “Heat Pump of the Year”

👉 Vote for “Best Manufacturer Customer Support”

👉 Nominate “Heat Pump Installation of Year”, “Best New Tech or Innovation” or “Turkey of the Year” here!

Latest Posts

Members Online