Notifications

Clear all

How do I choose a single room MVHR to prevent losing heat in my bathroom ?

heat-pump-newbie · 2024-02-22T11:57:56Z

Now that I've got a warm bathroom heated by my ASHP I want to prevent losing all that lovely heat from being extracted with the steam from the shower ? How do I choose what single room MVHR would be appropriate ? Everything I see online directs my to whole house systems or just technical stuff I don't understand. Help !

Page 2 / 2 Prev

Insulation

Last Post by heat-pump-newbie 1 week ago

18 Posts

7 Users

10 Reactions

3,441 Views

RSS

west

(@west)

Eminent Member Member

Joined: 2 years ago

Posts: 14

23/02/2024 5:57 pm

Mine was a waste of time and money, first installer did it wrong so all had to be ripped out by installer number 2, trading standards would not accept installer number 2 report as they were not independent!! second install, takes heat from shower rooms, but shower rooms never hot, as GSHP not right, so waste of time puts cold air in heated rooms, I have mine disconnected, put it on in the summer for cool air.

👍

ReplyQuote

heat-pump-newbie

(@heat-pump-newbie)

Reputable Member Member

Joined: 4 years ago

Posts: 169

Topic starter 23/02/2024 7:00 pm

@west this sounds like you're referring to something much bigger than a single room unit .

ReplyQuote

Brendon Uys

(@heacol)

Noble Member Contributor

Joined: 4 years ago

Posts: 408

24/02/2024 6:08 pm

Posted by: @editor

↑

@heacol this looks pretty awesome. Does/can it replace an existing extractor fan in a bathroom.

Yes it does, a direct swap, same 4" hole.

The mini is fine.

Director at Heacol | Expert Heat Pump Consultant | Book a one-to-one consultation for pre- and post-installation advice, troubleshooting and system optimisation.

👍

ReplyQuote

heat-pump-newbie

(@heat-pump-newbie)

Reputable Member Member

Joined: 4 years ago

Posts: 169

Topic starter 05/04/2024 10:46 pm

Update !
I have had an Envirovent Heatsava installed. It seemed noisy at first but now we’re used to it. It’s on all the time, uses only 20 W, it ramps up automatically when the shower is on and is quite obvious then, but clears the mist from the window and mirror very quickly. I like the constant fresh air flow and can’t smell the neighbour’s smoky log burner or bonfires as the filter works very well. Nearly all our trickle vents can be closed now as we have real fresh air coming in at last.
The only downside is that it’s quite big.

ReplyQuote

Transparent

(@transparent)

Illustrious Member Moderator

Joined: 4 years ago

Posts: 2446

06/04/2024 4:33 pm

As others might come across this topic in future, may I chip in and mention a two-room solution?

I was once faced with the need to draw in fresh air into the living area in a small flat, whilst also removing stale/humid air from the adjacent room with a shower and toilet.

The solution I hit upon was a tiny version of a 4-port MVHR unit, made by Vent Axia, and costing about £300. The HR100 has two varients; one allows access to the heat-exchange plates from the top, and the other from below. I chose the latter, and placed it directly above the doorway between the two rooms.

The HR100 has standard 110mm diameter ports which could be connected to solid-PVC tubing or flexible pipe with a reinforcement spiral wire to maintain the shape.

Save energy... recycle electrons!

ReplyQuote

heat-pump-newbie

(@heat-pump-newbie)

Reputable Member Member

Joined: 4 years ago

Posts: 169

Topic starter 07/08/2025 1:08 pm

An update on the Heatsava. It is the most difficult thing to clean. I had to get a strong bloke to remove the heat cell, couldn’t get all the crud out of it anyway, and trying to get it back into the unit is so far impossible. Should have got your one @heacol 🤦🏼‍♀️

ReplyQuote