Forums

Forums
Members
SUNandAIR
Activity
 
Notifications
Clear all
SUNandAIR
SUNandAIR
@sunandair
Member
Noble Member
Joined: Dec 30, 2022
Last seen: Jul 23, 2025
Profile Activity
Topics: 5 / Replies: 496
AllTopicsReplies
Reply
RE: Ecodan - flow rates, sensors, settings

I presented several pieces of data to try to convince that I’d done a fare bit of reading and testing. I think my install designer was as much swayed ...

10 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - flow rates, sensors, settings

1. [/quote]What were your drivers for replacing the pumps and removing the LLH, other than the 'usual' better design + increased efficiencies? Main ...

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - flow rates, sensors, settings

The solar panel, on 11th October is still providing 100% of our DHW needs on a sunny day like yesterday. However output will start to decline on cloud...

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan's terrible cloud software, lack of Tado support and limited control functionality

I don’t have any of these problems. ? but I don’t have a Tado either

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - flow rates, sensors, settings

@rhh2348 We have a Tempest Solar cylinder which has two coils and has 250l volume. Solar thermal array on the roof. The Grundfos circulation pumps ...

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - flow rates, sensors, settings

My bad…. the FTC6 does have separate speed settings as you say. It’s some time since I’ve looked at the on screen menu for pump speeds because we can...

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - flow rates, sensors, settings

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - flow rates, sensors, settings

Hi, @rhh2348 I’ve been looking for ways to control flow rates on our ecodan for over 2 years specifically for our Tempest cylinder. We now control ...

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Determining correct flow rate for a heat pump

It’s clear from what you say, above and what we have experienced in our own system that radiator systems behave very differently to screed laid under ...

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Determining correct flow rate for a heat pump

Hi @rhh2348 I have a question on your underfloor setup. The floor you’re describing above, assuming the 100mm thickness is a concrete screed, wou...

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan - flow rates, sensors, settings

Hi @rhh2348 , coming late to this thread as our Ecodan is off and our DHW is wet solar during the summer months. Have you found the answers to your ...

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: ASHP - a few (probably dumb) questions about the lived experience

So @lickofpaint I think you have your answer - “Your question isn’t so dumb…” as for lived experience we did some experiments on night time setba...

11 months ago
Forum
Air Source Heat Pumps (ASHPs)
Page 13 / 42
Share:

Join Us!

Podcast Picks

Latest Posts

Members Online

Click to access the login or register cheese
x Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
ShieldPRO →