Forums

Forums
Members
Clockworks
Activity
 
Notifications
Clear all
Clockworks
@clockworks
Member
Estimable Member
Joined: Jan 22, 2025
Last seen: Apr 26, 2025
Profile Activity
Topics: 2 / Replies: 53
AllTopicsReplies
Reply
RE: Ecodan Legionella cycle - immersion heater problem

Just to close this. Finally had the installer back last week to fit an immersion thermostat with a higher rating. As expected, no more rapid s...

5 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

Rather than disconnecting the Evohome boiler relay, I've added a switch across the relay contacts. This way, I can either have it on continuously, or...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

The reason why the pumps were stopping is because the heating was switching off. The Evohome controller starts "modulating" the BDR91 boiler relay a...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

I'm struggling to understand the "logic" used by the FTC6 to run the compressor and pumps. Graphs from today, 8 degrees OAT, WC curve target is 40 d...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

After a week of using AA mode, I've switched back to pure Weather Compensation mode. I had a couple of instances when the house started to get too c...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

I left it in AA mode overnight, with the wireless remote set to a target temperature of 19.5, and with the Evohome TRVs limiting the temperature in mo...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

Count me reassured . I'll switch back to WC mode, and remove the wireless remote if necessary. I'm reasonably confident that once I've rep...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

I'm pretty sure that I am overthinking it. It's just that so many people say " low and slow, cycling is bad", etc. If by that, they actually mean "l...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

There is a setting for "room temp control interval", but I'm not sure if this just applies in AA mode for reading the wireless sensor, or whether it a...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

Just to clarify, the hallway is heated by a 600x1100 T21 radiator. It does leak a fair amount of heat up the stairs, and into the integral garage (o...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

I don't think AA mode is going to work for me. The outside temperature dropped sharply overnight, from 8 degrees to 3 degrees in less than an ho...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Reply
RE: Ecodan 6kW - is it "cycling", or normal operation?

Looks like I got it wrong. With it set to "Main RC", it seems to be using the temperature sensor in the wired controller, but the wired controller i...

7 months ago
Forum
Air Source Heat Pumps (ASHPs)
Page 1 / 5
Share:

Join Us!

Podcast Picks

Latest Posts

Members Online

Click to access the login or register cheese
x Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
ShieldPRO →